DODGE RAM FORUM banner

2008 ram Ac cooling fan

1K views 4 replies 2 participants last post by  panther05 
#1 ·
Fan only kicks in if i hold wireing harness & now liquid shooting out from behind compressor. Can't tell what it is! ANY suggestions are really appreciated
 
#3 ·
I am in Coral Springs which is by Ft Lauderdale. If I hold the wiring harness where it plugs into fan and push downward the fan spins. Not sure if shorting out but checkked all wires and nothing loose. The liquid shooting out seemed like it was coming from water pump, but appeared to be from somewhere right behind compressor & felt oily but clear! Thanks for responding
 
#4 ·
As far as the fan, sounds like a problem with the connector/plug. I'd disconnect it, inspect for loose/broken tabs in the connector, and put dialectic grease all over it the reconnect it. If holding/wiggling the connector makes it go on/off then it must be something with the connector/plug.

I don't know about the leak...
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top