As long as its worth it.. I don't mind paying a good price for them.. I'm just a little nervous on the halo/LED wiring and splicing.. Just because everything works good now.. I don't want to ruin anything.. My last ram I through some HIDs in and eventually they stopped working and I had all these issues with the lights then finally had to pay to go back to new stock lights.. Same with cutting this 1" hole in the back of the headlight for the HIDs so if I wanted to go back to stock due to problems with the HIDs i'm going to have to make adjustments to the housing
And to be 100% honest, I don't use my high beams with these projectors. I have them aimed a touch high and I can see for ages.
Don't get me wrong I get flashed MILLIONS of times by other people, but what can I do they are my low beams.
I just feed them the highs and they get the point and shut theres off.
But the projectors were worth the money, especially up north here. The HIDS are incredible I would never go back to stock halogen
Could you please actually post the thread where you install them to the stock quad housings.. I haven't decided whether or not to get the projectors.. Is the light output a large difference between the HIDs in the stock lights and the HIDs in the projectors ? any help would be great Justin!
Thanks for the info, might be my trucks christmas present ha
But to install the rubber grommets in the back of the stock housing. You just need a 1" wood drill bit. Shove her in the centre and take your time... if you rush it you will crack the plastic cover.
Size the bit up to your rubber grommets first to make sure the hole won't be too large. I am 99% sure It was a 1" bit. But just double check.
Remember to seal those grommets too, you don't want any moisture getting in your headlamp, than it just causes problems and looks like crap.
Just send a pm if you got any more questions, well when your over the 25 post mark lol