DODGE RAM FORUM - Ram Forums and Owners Club! - Dodge Truck Forum

DODGE RAM FORUM - Ram Forums and Owners Club! - Dodge Truck Forum (
-   Body & Interior (
-   -   Center Console Removal -Help!!!!!!!!! (

sudd54 01-09-2012 06:36 PM

Center Console Removal -Help!!!!!!!!!
Hoping someone could help me out. I have a 2011 Dodge Ram Quad Cab and I am trying to take the box out of the center console to mount a holster. Took the 4 screw out but the thing will not move an inch. Anybody got any suggestions???

GTyankee 01-09-2012 06:46 PM

there are 2 different type consoles
1 with the bucket seats & full floor console, 1 with out the bucket seats

we need to know which you have

also, which console are you referring to, the seat console or the dash console

sudd54 01-10-2012 09:20 AM

It is the console with the bucket seats with the shifter. I basically want to remove the deep inside tray under the arm rest so that I can mount a holster. Again, I removed the 4 screws and it didn't budge.

Thanks for your help!

wrightgang 06-11-2012 11:17 PM

Center Console Removal
May be a little late, but I have a how to video on this at

JBassRN 05-11-2013 08:03 PM

4 Attachment(s)
I just did the same thing and was able to install without completely taking out. Go to the back seat and on the console where the vents come out, that whole piece will just pop off. Then move your drivers seat all the way foreward and look near the floor on the bottom on the console *looking from the back seat*. Remove this screw. This piece will not pop off (some), just enough to get your hand in to secure bolts. Then drill holes into the console. There is about a 1inch gap from the console to the outer piece. Then secure holster and put back together.

All times are GMT -4. The time now is 08:40 PM.

Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2015, vBulletin Solutions, Inc.
= Copyright a Network Site =Ad Management by RedTyger