DODGE RAM FORUM - Ram Forums and Owners Club! - Dodge Truck Forum

DODGE RAM FORUM - Ram Forums and Owners Club! - Dodge Truck Forum (http://www.ramforumz.com/index.php)
-   Dodge Ram Detailing and General Maintenance Forum (http://www.ramforumz.com/forumdisplay.php?f=38)
-   -   Water Spots on New Black Ram (http://www.ramforumz.com/showthread.php?t=107244)

65Arboc 03-12-2012 11:31 AM

Water Spots on New Black Ram
 
Washed my 2012 Black Ram yesterday and noticed lots of water spots on the hood. Probably from going thru auto washes all winter long. What should I use to get these off an otherwise beautiful black paint job?

Thanks,

Jim in Pa:4-dontknow:

SJP2X11RT 03-13-2012 09:44 PM

My BB Ram has held up pretty good over the past year and I mainly run it through car washes.

My Torred Challenger on the other hand loves to leave water spots. I spent 30+ hours over a few weekends using clay bars, buffers and polishes to get rid of them.

daggertats 03-14-2012 05:28 AM

i always dry my truck off after a wash and i use eagle one wax as you dry with the absorber shammy. leaves water marks nonexsistant. a clay bar would probably take those off .

454tahoe 04-07-2012 10:01 PM

Clay bars dont always work but, it is a good start,
for me the best way for some time,
1. Wash
2. Clay if clay removes the spots, then wax
3. If not then compound with ultimate compound meguairs or any other compound
4. Polish out compound
5. Then wax over

this will leave most if not all fine scratches out of the paint and all swirls out as well and the spots should be gone as well.
This will also leave your paint silky smooth and feeling like glass as it should always feel.

Any further questions please ask away.

primo spaghetti 04-08-2012 03:05 PM

the water spots are hard water deposits. make sure you dry your truck off after washing, and they should virtually disappear. unfortunately, there are mineral deposits in your wash water. People will look at you strange, but hit your truck with the leaf blower after you wash it and youll see those spots disappear. and dry with a detail mist also will help.

nitrox28 04-22-2012 01:39 AM

When I detailed my new-to-me truck this past weekend, I noticed the hood was covered in water spots. Like it had been in the rain and then sat out in the hot sun for a couple of days. I whipped out the trusty clay bar, and that didn't work at all. I was shocked. Next step will be to use a buffer and some polish. If that doesn't work, I'll be out of ideas.

jc4041 04-22-2012 05:40 AM

look for Ducky Water spot remover....in the boat section....have friends in the LX club that like it

CanDan 05-01-2012 03:58 PM

Wash your truck by hand with a good automotive soap. Dry it in the shade with a soft bathroom towel. It is better when it is damp. Go over everything twice. Don't let the truck dry until you dry it or you will get water spots.

Drive through car washes are great in the winter to keep the salt off but make sure you don't use the wax and coating options they provide. They go on before the vehicle is clean and trap in dirt. You will usually only notice this on a black vehicle.

If the water spots are really bad try a clay bar and then a good hand wax. I don't use electric buffers.

Here is my guide to always having a perfect looking black vehicle. (I am now on my third one)
Approximate time (1-2 hours)


1. Find a shady area to wash
2. Rinse the roof of the truck with cool water (never hot)
3. Using an automotive soap start washing the roof with a terry cloth or soft sponge, making sure that the areas that you are cleaning are always wet ahead of time.
4. Rinse the all of the soap off of the roof of the truck
5. Rinse the windows top half (bottom of window line and up) of the cab and wash as stated above. Then rinse.
6. Get a new clean bucket and terry cloth or sponge
7. Repeat the above working your way from the top down and make sure you keep all of the areas you have washed wet. If it dries you will get water spots.
8. Get a new terry cloth or sponge for the wheels and tires and clean them with the same soap as you used for everything else. NEVER USE THIS FOR ANYTHING BUT WHEELS AND TIRES, this is your new wheel/tire cloth.
9. Make sure everything stays wet
10. Using a bath towel start on the roof and start drying working your way down to the bottom (not wheels and tires), go over it very quickly, this is the first coat of drying. You will have to ring out the towel a few times as you go.
11. Go over the entire truck a second time with the damp towel. This is the final coat. It does not have to be perfectly dry but should be drying within 20 seconds of your wipe.

Important Tips:
a) Light reflects in straight lines. Wash and dry in straight lines from front to back, leave the circles for crop mysteries.
b) Depending on how dirty your truck is will depend on how often you will have to change buckets and terry cloths or sponges. The minimum you need is 2. If you use dirty to wash you will scratch the surface with dirt particles and only be spreading around dirty water.

Wheels

With another dedicated wheel/tire towel dry your wheels and tires.
Clean your tires with your favourite tire cleaner. Make sure they are dry before you drive away or you will spray tire cleaner up the side of your truck.

The above is what should be done weekly or as needed.

Waxing (do this once every month or 2) (Approximate Time - 2-4 hours)
I use Turtle Wax colour match (Black). I have tried Mothers, McGuiers(sp?) and many other products but I find this works the best on black. (hint - wear gloves or you will have black nails and hands)

1. Wash like above
2. Keep vehicle in a cool dust free area. I usually use my garage and have a garden hose running (sprinkler or trickle) to keep the floor damp and the dust down.
3. Have a lot of light, some that you can move to different angles so that you can see everything and make sure you haven't missed anything.
4. With a new terry cloth apply a small amount of wax to the cloth and start on the roof working your way down. You can apply using circles here. You will probably use 2-4 terry cloths for this.
5. Starting at the first place you applied the wax (the roof) start buffing using a micro fibre cloth and rubbing in straight lines from front to back until buffed to your shiny desire. Work your way around the entire vehicle in the order you applied the wax.
6. Once finished I find a terry cloth works well to get any missed spots or hard to buff areas. Let the cloth do the work. You should be buffing a lot but not hard.
7. Walk around the truck looking from different angles to see if you missed any areas.
8. Drink a beer and just stare at you awesome job.

There are a lot of different ways to wax and clean your vehicle. This is what I find works best for black. Some things you can get away with on other colours (colors for my American friends) you wont be able to with black.

If you some how manage to destroy or damage yourself or your vehicle in anyway I take no responsibility for it. I am only posting what I do. It is your vehicle and you should clean it to your own digression.

Jayincali 07-25-2012 02:27 PM

Pretty good post above. But I cringe at reading wash with a terry towel and dry with a bath towel. Might as well have the car dealers wash it as thatís all they do. Use a waffle weave MF towel, I use one in each hand and never have to wring it out. The only reason you don't see the ton of marring and swirls you have in your paint is due to that Turtle wax black wax you are using. That is pretty much 90% filler with a black tint to cover it all up. I'm not knocking your practice, but just letting you know if you do an IPA wipe down (I use 30% IP alcohol 70% water) and wipe a panel you will be amazed how many swirls you have. I see your truck is brand new, so if you don't have many now, you will in a year from now and will need major paint correction.

To the OP, if you can't remove the water spots with a clay bar, try vinegar/water 50/50. That should remove the water spots if they are fairly new. (use on windows as well if you have spots) If they are pretty old, then you will need a compound and buffer to remove them as it has etched into your clear. After a wash, use some detail spray before drying. Your first mistake is a drive thru wash...

medic18d 11-19-2013 02:50 PM

Quote:

Originally Posted by 65Arboc (Post 748271)
Washed my 2012 Black Ram yesterday and noticed lots of water spots on the hood. Probably from going thru auto washes all winter long. What should I use to get these off an otherwise beautiful black paint job?

Thanks,

Jim in Pa:4-dontknow:

all you need is a can of FAST WAX , miracle stuff.
removes bugs water spots and most of all resists finger smudges on black paint
works on paint lights , windows . and wheels
you can do all that other stuff or wash your vehicle , dry it and spray fast wax on it . and be done . dont take my word for it . try it


All times are GMT -4. The time now is 02:29 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
vB.Sponsors
= Copyright RamForumZ.com a Gigathreads.com Network Site =Ad Management by RedTyger