DODGE RAM FORUM - Ram Forums and Owners Club! - Dodge Truck Forum

DODGE RAM FORUM - Ram Forums and Owners Club! - Dodge Truck Forum (http://www.ramforumz.com/index.php)
-   Custom Chassis - Drive Line - Suspension - Wheels and Tires - LIFTING - Dodge Ram 4x4, 2x4 (http://www.ramforumz.com/forumdisplay.php?f=14)
-   -   BDS lift kit issue (http://www.ramforumz.com/showthread.php?t=107317)

demco11 03-12-2012 10:41 PM

BDS lift kit issue
 
Purchased a lift kit through a supplier online and had a local shop install it for me.

I have a 2008 dodge ram 1500 4x4 quad cab short box

the kit is a BDS 6'' lift with new leafs for the back.

Upon picking my truck up from the shop I noticed the rear is sitting WAY too high.

Does anyone else have this lift kit WITH the leafs? what are your measurments from the centre of the wheel to the top of the wheel well lip?

My front is 26.5'' and rear is 32''.


I checked the part numbers on the leafs and they are correct (both the sticker and the stamped number confirm it) The shop believes they sent me the wrong leaves even though the part number is correct. In talks with BDS about this because my truck looks stupid with how high the rear is sitting when on a flat/level surface.

Should I add a front level kit + bilstein 5100's? is that even possible? I would need to like the front by 4 to 5'' to make it look good but I dont think the rear end is safe having been lifted so high with these leafs.

http://i2.photobucket.com/albums/y21/demco11/photo.jpg

Jerkbait 03-13-2012 01:26 AM

check out this post http://www.ramforumz.com/showthread.php?t=90657 bighorn4life he has a similar set up.. he shud be able to help you. send him a message

RAM303 03-13-2012 05:41 PM

Dang, Your better off putting in your stock ones with 3" blocks.

demco11 03-13-2012 11:16 PM

Anyone with the same truck and lift can out there? help is needed urgently to determine if the front kit I got was mislabeled as a 4'' lift instead of 6'' or if the rear is too high.

Schmitz 03-14-2012 01:28 PM

I'd say both are wrong you have almost 6 inches of difference I'd put the stock leafs in for now, do you know how much higher your front is now than it was stock?

demco11 03-14-2012 04:30 PM

I do not know, measurments were not taken prior to the install.


All times are GMT -4. The time now is 11:46 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
vB.Sponsors
= Copyright RamForumZ.com a Gigathreads.com Network Site =Ad Management by RedTyger