For those who have the Borgeson steering shaft...
The instructions say to tighten the set screws on the upper u-joint (the one with the double d shaft) so that they make a mark and then drill a dimple in the shaft. My question: How did you drill the "dimple"???? I have no idea how to get a drill anywhere close. :(
suggestions greatly appreciated. :)
nobody has installed a borgeson steering shaft???
|All times are GMT -4. The time now is 02:13 AM.|
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
= Copyright RamForumZ.com a Gigathreads.com Network Site =Ad Management by RedTyger