DODGE RAM FORUM - Ram Forums and Owners Club! - Dodge Truck Forum

DODGE RAM FORUM - Ram Forums and Owners Club! - Dodge Truck Forum (
-   Body & Interior (
-   -   Headlights (

Jodiwon 05-20-2012 11:44 PM

How in the heck do you replace the light bulbs on the 2012 Ram? Do you have to take the whole assemble out?

Stump3r 05-21-2012 12:33 AM

You most certainly do!
Two schools of thought.... some take out the entire grill however if you have a long extension and some duct tape you can get the headlights out without going through the hassle of pulling the grill.

1500ram12 05-21-2012 05:28 AM

its very easy to do. pull the plastic air dam off (4 push pins) I think their is 4 bolts holding the grill in. Then pull the bottom of the grill straight out. 2 spring snaps hold the bottom in. should be 2 bolts on each light. now the hard part. in the wheel well you will see a panel held in by a push pin, open the panel. first time take a flash light look in side you will see a white plastice flat piece that needs to be pushed up. once thats done the light will slide out. sounds complicated but its not. first light will be the hardest but once you get the hang of it its easy.

All times are GMT -4. The time now is 04:38 AM.

Powered by vBulletin® Version 3.8.10 Beta 2
Copyright ©2000 - 2016, vBulletin Solutions, Inc.
= Copyright a Network Site =Ad Management by RedTyger