DODGE RAM FORUM - Ram Forums and Owners Club! - Dodge Truck Forum

DODGE RAM FORUM - Ram Forums and Owners Club! - Dodge Truck Forum (http://www.ramforumz.com/index.php)
-   Towing (http://www.ramforumz.com/forumdisplay.php?f=202)
-   -   integrated brake controller wiring (http://www.ramforumz.com/showthread.php?t=124998)

tteachman 10-31-2012 12:49 PM

integrated brake controller wiring
 
I have purchased and rec'd the integrated brake controller for my 2010 Dodge Ram and went to install when I noticed I do not have both plugs for the controller. I have done a lot of research and have wired the B Connector myself but every time I connect the B3 (Fused ignition Run/Start control output) to the pink/light green stripe wire the truck will not start. Any help would greatly be appreciated. I cannot return the inegrated brake controller and do not want to be out $200!

Dragonmaster13 11-01-2012 02:09 PM

It will work on just 1 plug. The little plug is just for evic. If you have evic you would still need to get it flashed for it to show up.

clatla 01-09-2013 01:50 PM

My factory controller died so I am installing an aftermarket one. If any of you that installed the Dodge controller and still have the dash piece that you had to take out let me know. I need the tan color. Shoot me a PM.


All times are GMT -4. The time now is 01:05 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2015, vBulletin Solutions, Inc.
vB.Sponsors
= Copyright RamForumZ.com a Gigathreads.com Network Site =Ad Management by RedTyger