DODGE RAM FORUM - Ram Forums and Owners Club! - Dodge Truck Forum

DODGE RAM FORUM - Ram Forums and Owners Club! - Dodge Truck Forum (http://www.ramforumz.com/index.php)
-   2010 Dodge Ram Forum (http://www.ramforumz.com/forumdisplay.php?f=79)
-   -   Routing through Firewall (http://www.ramforumz.com/showthread.php?t=133098)

Darkknight3829 02-08-2013 07:34 PM

Routing through Firewall
 
Im in the process of thinking of a way to route my nitrous line (about 1/4 inch thick) its -4AN line, through the firewall and into the engine bay. Now the hole that i used for my fogs and nitrous electrical in my opinion is way to tight to fit the nitrous line through. Im really looking for some help from you guys. Any opinions, advise? Thanks

Excoastie 02-09-2013 08:55 AM

I think the best thing that you could do, though I admit that it won't be easy would be to find a good spot in the firewall, then drill a hole.

I'm sure that they make some sort of "through wall" fitting that you can install where you can attach the nitrous line to the fitting on each side of the fire wall. This will not only give you a cleaner look, it'll mostly likely cut down on the possibility of snagging or scraping the line at some point in the future.

good luck


Exco

Outlaw 02-09-2013 12:12 PM

Drill thru the clutch master cylinder filler plate.

ArmyofOne 02-15-2013 12:55 PM

Quote:

Originally Posted by cbrambo497 (Post 1007327)
Drill thru the clutch master cylinder filler plate.

Truth! I drilled through mine to run air lines for Total Load Control:

http://i248.photobucket.com/albums/g...6/100_3276.jpg

Underhood view:
http://i248.photobucket.com/albums/g...6/100_3278.jpg


All times are GMT -4. The time now is 09:13 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
vB.Sponsors
= Copyright RamForumZ.com a Gigathreads.com Network Site =Ad Management by RedTyger