Long over due but here we go...
Ok so this weekend was very productive I got to connect my cameras the front, and rear and I started to prep the rear seats for the amps. I will add more to the post as I go on
1. Switched the factory radio for a 730n and Lockpic set up navigation and movie in motion.
Straight forward pull the old radio and switch it for the new one all standard DIY routine.
2. Installed the front and rear cameras, ran the wires, (Rear) removed the tail gate cover and ran the wires thru the factory location and into the cabin. Front was modified because of where I wanted it, ran the wires thru the fire wall as well. (The front was all costume done by me) Installed the cameras to the lockpic. Connect it to the factory radio and connect the harness to the Lockpic. Straight forward no surprises. After the install I noticed the images were upside down on the monitor….. DAM…. I rotated the rear camera perfect the front was trickier I disassembled the housing removed the camera rotated it 180*and hot glued it to hold it and reinstalled it Perfect….
3. Also last week I installed my new 12” Pioneer sub replacing the center jump seat. Remove the passenger seat allowing easier access to the jump seat remove the jump seat install the sub box and reinstall the passenger seat. “WALA” you were never there……
4. Remove the rear seat and raise it via 3/4 “ blocks painted black and reinstalled the rear seat allowing access to the rear of the cab for installation of my 3 Rockford Fosgate Amps are not in yet
B Pillar without tape ( New Version)
That's all I could get up for now I will add more any questions I'm more than happy to help / advise.
looks like you've been hard at work! good work.
Some people go see a shrink I go to the Auto Parts Store and spend time with the truck.....
Dam it's actually costing me more money oh well so much for that theory..
Looks great! You should have this in the Build Thread section so more will see it. not everyone will venture into the regional sections of the forum.
Edited to ad, I have asked for this to be moved to the Complete build section.
Shawn I was trying to do that but I can't figure out how to ?
can I pull it from here and put it there how ?
Thank You Shawn
Ok thanks how can I do that in the future ?
only mods can move threads around to different sections. just be sure u are in the appropriate section before u click "new thread".
Nice mods, great stuff, keep up the great work and pics, I love pics of what others are doing.
In the begin there was boredom
Then came excitement
|All times are GMT -4. The time now is 12:29 PM.|
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2015, vBulletin Solutions, Inc.
= Copyright RamForumZ.com a Gigathreads.com Network Site =Ad Management by RedTyger