||04-29-2013 04:40 PM
Brake flaring tool review
I bought this tool a while ago and have used it on my 02' ram and my Golf. The tool is a bit pricier than some other clamp type tools, but after using both types, this is the way to go. I have used this on ferrous and non ferrous tubing. Brake lines and gas lines. With both tools, you use a tubing cutter, install your nut, ream the tubing. With the c-clamp type of tool, I always got so-so results. With this pro tool, everytime it is PERFECT. To use this tool, set the base in a vice and secure. Insert the handle into tool. Next, insert 1/2 of the die for your size of tubing, cover with second half of die. Close the clamp and tighten. Spin the turret to the part that kind of looks like a plain flat bolt and pull the handle. This makes sure your tubing is flush to the face of the die. Next, rotate the turret to Op 1 [operation] to your size of tubing; pull the handle. Next, rotate the turret to Op 2, your size of tubing and pull the handle. Your done with a perfect flare. This tool makes SAE and European DINN flares. Simple and perfect. Can't say more or how easy it is. Here is a utube vid on some used including the one above. http://www.youtube.com/watch?v=9MXa4e_0OrU
||05-02-2013 01:26 PM
Nice review. I needed one of these while repairing my 20 gallon air compressor. Borrowed one very similar and it worked like a charm.
|All times are GMT -4. The time now is 06:31 AM.
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
= Copyright RamForumZ.com a Gigathreads.com Network Site =Ad Management by RedTyger