DODGE RAM FORUM - Ram Forums and Owners Club! - Dodge Truck Forum

DODGE RAM FORUM - Ram Forums and Owners Club! - Dodge Truck Forum (http://www.ramforumz.com/index.php)
-   Custom Chassis - Drive Line - Suspension - Wheels and Tires - LIFTING - Dodge Ram 4x4, 2x4 (http://www.ramforumz.com/forumdisplay.php?f=14)
-   -   Few Questions...4x4 shops and Rims (http://www.ramforumz.com/showthread.php?t=147193)

Rhino65 07-10-2013 02:47 PM

Few Questions...4x4 shops and Rims
 
I picked up a 2007 Ram 1500 and I'm look'in to put a 4" Rough Country lift on it.Anyone have any idea what an estimate for labor would run to have it installed around South Plainfield, New Jersey?Also would appreciate names/websites of any 4x4 shops in the area. The current tires are P27565R18's...what's the biggest tire I can get on the current rims?Thx for any and all responses

brandonjansen 07-10-2013 03:25 PM

My guess is around 6-7 hour install time for the lift so at $80 an hour you're look at around $480-$560. Not sure of any shops in the area as I'm from the west coast. Hopefully someone will chime in for you on that.

As far as tires go with the 4" lift you'll clear 35x12.5's no problem but I believe you'll need 1/4" spacers if you're using the stock rims.

Rhino65 07-10-2013 04:17 PM

I don't believe the rims are stock although I don't know for sure, are you saying that 35's will fit stock rims?

brandonjansen 07-10-2013 04:19 PM

You could post a picture of the rims. We'll let you know pretty quick.

Yes, you can fit 35x12.5's on stock rims no problem. You just need 1/4" spacers to avoid rubbing on the UCA.

gonefishin776 07-10-2013 04:36 PM

yeah RCX says 5-6 hours install time. But with an older truck you could probably tack on another hour. So 7 hours at the shop rate of usually $80-90/hr then another 70-90 for an alignment.

Rhino65 07-10-2013 05:39 PM

Can't figure out how to post a pic

brandonjansen 07-10-2013 05:42 PM

Here's a few threads explaining how to do it.

Using photobucket (best way IMO): http://www.ramforumz.com/showthread.php?t=139666

Using Ramforumz: http://www.ramforumz.com/showthread.php?t=38375

Rhino65 07-10-2013 06:01 PM

http://http://s190.photobucket.com/u...tml?sort=3&o=0

Rhino65 07-10-2013 06:02 PM

Figured it out...

brandonjansen 07-10-2013 06:06 PM

If you post the IMG code rather than the link it will post the picture directly onto the thread.

Do you have a picture looking back from the front of the truck showing the lower control arm and the CV shaft?

EDIT: A picture like THIS is what I'm talking about.


All times are GMT -4. The time now is 12:30 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
vB.Sponsors
= Copyright RamForumZ.com a Gigathreads.com Network Site =Ad Management by RedTyger