DODGE RAM FORUM - Ram Forums and Owners Club! - Dodge Truck Forum

DODGE RAM FORUM - Ram Forums and Owners Club! - Dodge Truck Forum (http://www.ramforumz.com/index.php)
-   Custom Dodge Ram Performance Mods - Engine - 8.0 Liter V10 (http://www.ramforumz.com/forumdisplay.php?f=87)
-   -   V10 Conrod questions (http://www.ramforumz.com/showthread.php?t=147242)

Valvebounce 07-11-2013 05:34 AM

V10 Conrod questions
 
Bit of a newbie question for the experts.
Are the Conrods from the Truck V10 engines, the same as the rods found in the Viper V10 engines?
I'm asking as I read somewhere that the Ramm engines are somewhat different to the Viper ones. (different block material?)

69beeguy 09-02-2013 01:15 PM

everything
 
hey,
i have been looking into this for a project i would like to start. between viper and ram V-10's virtually everything is different. however, if you are looking into V-10 mods, think 5.9 magnum plus 2 cylinders. the 8.0 has a larger stroke than the 5.9 and the bottom end is a little different too. but rods and pistons are the same. i have been looking into 4.0 jeep con rods. they are 100g lighter, but much stronger. and there is a ton of them out there. they also have smaller rod journals, but same width. this way, you can offset grind the crank and get close to 500 cubes depending on overbore. the 8.0 has a 8.4:1 compression ratio. i do not physically have one yet to tear apart, but this should bring you close to zero deck. i am looking at picking one up here soon. i will have to beef up my engine stand because the 8.0 is 800lbs+.

jim


All times are GMT -4. The time now is 04:44 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
vB.Sponsors
= Copyright RamForumZ.com a Gigathreads.com Network Site =Ad Management by RedTyger