DODGE RAM FORUM - Ram Forums and Owners Club! - Dodge Truck Forum

DODGE RAM FORUM - Ram Forums and Owners Club! - Dodge Truck Forum (
-   Custom Chassis - Drive Line - Suspension - Wheels and Tires - LOWERING or STANDARD (
-   -   4 X 4 Front end (

larry5061 09-21-2013 01:05 PM

4 X 4 Front end
Hey everyone,
I have an 09 short box standard cab SLT.
Last summer I installed McG's rear 2" lowering springs, now they have settled the truck sits level. I want a slight rake. Any suggestions on front springs, spindles?, I don't want any cv issues.
Thank you

CdnoilRAM 09-21-2013 09:49 PM

If you don't want CV issues you're very limited. You can swap on a set of 2WD front knuckles (spindles) and that'll bring you down about another inch without maxing your CVs or upper ball joint. Or the easy way is to use a set of Ground Force front lowering springs. I ordered a set directly from them so I didn't have to pay for a full kit.

I'm down 4/6 on my 4wd now, just waiting to see what the next weakest part is. I've already replaced CV joints with high angle Kore ones, upper control arms with a uniball joint, and will be notching the rear soon. Don't do what I've done unless you really want to be this low, it's a major PITA.

All times are GMT -4. The time now is 06:24 AM.

Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2015, vBulletin Solutions, Inc.
= Copyright a Network Site =Ad Management by RedTyger