DODGE RAM FORUM - Ram Forums and Owners Club! - Dodge Truck Forum

DODGE RAM FORUM - Ram Forums and Owners Club! - Dodge Truck Forum (http://www.ramforumz.com/index.php)
-   Custom Dodge Ram Performance Mods - Engine - Dodge Cummins Diesel (http://www.ramforumz.com/forumdisplay.php?f=23)
-   -   Extra Gauges for your diesel? (http://www.ramforumz.com/showthread.php?t=39347)

BubbaDuss 06-01-2009 08:46 PM

Extra Gauges for your diesel?
 
I was curious if anyone here has a gauge pod with extra gauges in a 03 and new ram.
I'd like to know how much boost the turbo is putting out, and the trans temp. stuff like that.


anyone know where I would find them?

I found one on BMC's website, but I have a driver assist handle on the A-Pillar

Sparky 06-01-2009 11:35 PM

I think that you would have to remove the handle and put on the pillar piece instead.

here is another link

http://www.glowshiftdirect.com/Dodge...auge-Pods.aspx

carscars11 11-05-2009 02:43 PM

found this website whn i was looking for parts for my truck...they have them for the front dash above the steering wheel and for the area below the ac controls...dont know if they will fit ur truck but...hope this helps
...
http://www.rpmoutlet.com/ramhemigaugea.htm#1

mmbroussard 11-05-2009 11:43 PM

A pillar mounting is common, but there are other locations as mentioned. The a pillar trim with the grab handle is removed and the new piece with the pods replaces it. There are a few that keep the handle nut usually only holds one round gauge or a digital display. I heard some good things about the glow shift. Look around many choices for gauges and mounting. I think Isspro Performax gauges allow for easy installs and upgradeable to 17 gauges. it uses an electrical signal box. But you cant beat real gauges.

varmintshooter 12-17-2009 01:44 PM

OK so I just got a smokin deal on a 2008 Ram 2500 with the Diesel and would really like a transmission temp gauge and maybe a boost gauge.

For those of you that went the Glow Shift Pod route how difficult was the installation? The glow shift instructions say to remove the factory temp sending unit that works with the dummy light. Is this OK?

This website is great, lots of information here.

Thanks in advance!

Smokeeatertk28 01-14-2010 09:00 PM

Hey guys. if ur looking for gauges and a good place to put them with out putting them on the a piller. Go to genos.com they have one that go's above ur rear view. my whole kit costed 250. trans pyro and tranny temp. Genos takes care of you always.


All times are GMT -4. The time now is 12:12 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
vB.Sponsors
= Copyright RamForumZ.com a Gigathreads.com Network Site =Ad Management by RedTyger