DODGE RAM FORUM - Ram Forums and Owners Club! - Dodge Truck Forum

DODGE RAM FORUM - Ram Forums and Owners Club! - Dodge Truck Forum (http://www.ramforumz.com/index.php)
-   Custom Dodge Ram Exterior Modifications - Body Mods - Body Kits (http://www.ramforumz.com/forumdisplay.php?f=15)
-   -   Nerf bar question (http://www.ramforumz.com/showthread.php?t=40792)

wermbang 08-06-2009 10:14 PM

Nerf bar question
 
I am in need of some pics of how nerf bars attach to my truck. I have an 01 1500. thanks.

Excoastie 08-07-2009 07:55 AM

They're pretty straight forward on how they install. The brackets will only go on one way. The only issues that I ran into was the lock washers were a bit tight on a couple of the bolts.

I'll try to go out and crawl under the truck and get a couple of pics (after I wake up a little), but they're not tough to install....

Exco

wermbang 08-07-2009 12:22 PM

Quote:

Originally Posted by Excoastie (Post 72764)
They're pretty straight forward on how they install. The brackets will only go on one way. The only issues that I ran into was the lock washers were a bit tight on a couple of the bolts.

I'll try to go out and crawl under the truck and get a couple of pics (after I wake up a little), but they're not tough to install....

Exco

I am actually modifying a set that came off a H2 Hummer. So just needing spot where they normally mount, to see how close I can get them.

Toms Blue Ram 1500 08-07-2009 03:10 PM

I'd buy the ones for the truck . Quad cab truck nerf bars have the step for the rear door . Make sure the ones you get are stainless steel . I got the regular steel ones and got three years out of them until one day I was picking my ass up off the ground .

deanthecrabman 08-11-2009 05:21 AM

Ordered mine from TruckChamp.com, under $200 for everything. Stainless steel, put on in under 2 hours. They say no drilling required, but you do need to drill 2 holes for the support bracket. Instructions were clear, except for where to drill for the brackets. Once I had that on the driver side, passerger side went on in about 40 min.


All times are GMT -4. The time now is 06:31 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
vB.Sponsors
= Copyright RamForumZ.com a Gigathreads.com Network Site =Ad Management by RedTyger