DODGE RAM FORUM - Ram Forums and Owners Club! - Dodge Truck Forum

DODGE RAM FORUM - Ram Forums and Owners Club! - Dodge Truck Forum (http://www.ramforumz.com/index.php)
-   V10 Specific Topics (http://www.ramforumz.com/forumdisplay.php?f=214)
-   -   V 10 trying to stall (http://www.ramforumz.com/showthread.php?t=45312)

badazram 12-20-2009 11:23 PM

V 10 trying to stall
 
when i back up slowly and tap the gas to go a little further....the truck tries to stall....the needle dips down to around two hundred RPM and then comes up...I was just wondering what could cause this??:4-dontknow:

Toms Blue Ram 1500 12-20-2009 11:30 PM

Try cleaning the throttle plate and bore with throttle plate cleaner . If you use carb cleaner don't spray it in . Spray a rag and wipe it out .

RamTech 12-20-2009 11:36 PM

I like using a soft bristle toothbrush for the heavy deposits and following it up with a rag.

98sst 12-20-2009 11:43 PM

I totally had this happen recently. I did exactly what tom said, clean your throttle body. I took it off, but if you don't want to do that, you can very easily spray a rag and wipe it down. Open up the flap and wipe down there as well.


Also... In the back of your throttle body is a little motor with a wire harness going into it. there will be 2 hex nut screws, it is your Idle Air Control Valve. Mine had a ton of grime on it, and I cleaned it up with the TB cleaner as well (sprayed onto a rag) and the problem is solved.

badazram 12-21-2009 12:18 AM

hey thanks guys i'll try that and get bac to you sometime....Kev


All times are GMT -4. The time now is 07:52 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
vB.Sponsors
= Copyright RamForumZ.com a Gigathreads.com Network Site =Ad Management by RedTyger