DODGE RAM FORUM - Ram Forums and Owners Club! - Dodge Truck Forum

DODGE RAM FORUM - Ram Forums and Owners Club! - Dodge Truck Forum (http://www.ramforumz.com/index.php)
-   Custom Dodge Ram Performance Mods - Engine - 5.2 Liter V8 (http://www.ramforumz.com/forumdisplay.php?f=86)
-   -   Cut out fenders flared? (http://www.ramforumz.com/showthread.php?t=55645)

kicknjeep 06-19-2010 01:32 PM

Cut out fenders flared?
 
Do they make these? and if so where can I get them because I can't find them anywhere. they will be for my 1995 Ram 1500

erm 06-19-2010 01:48 PM

So you are planning on cutting your fender openings and are looking for a set of flares to throw in there after you do the cutting?

It might be easier to get some dimensions on a set of flares and transfer those dimensions to your fender cut lines.

kicknjeep 06-19-2010 02:37 PM

Yes planning to cut fenders seeing how there are several blemishes around them that C/O flares will cover. Well that's my plan anyway. Want to keep C/G
as low as possible to fit either 32" or 33" tires. Hoping for flares and maybe 1" Body lift to achieve this.

RamTech 06-19-2010 02:46 PM

Am I seeing things or does Bushwhacker not offer cut outs for the 94-01 Rams?

erm 06-19-2010 02:51 PM

I looked at their site too. Didn't see any cutout flares there.

RamTech 06-19-2010 02:52 PM

I'll look through some of my 4X4 magazines and see if I can find anything.

erm 06-19-2010 02:54 PM

I saw some on autoworldaccessories.com that were listed as Bushwacker pocket style cutout flares. There's a whole list of them there that you could look at to see if your truck is listed.

Also, check out junglefenderflares.com for 94 - 01 Ram cutout flares.

kicknjeep 06-19-2010 02:58 PM

That is what i have been running into, None for those years. the pocket style C/O flares is what I'm looking for.I'll check out the sites you guys posted and see what I can come up with. Thanks

RamTech 06-19-2010 03:00 PM

The pocket style looks like the cut outs but it specifically says you don't do any cutting.

erm 06-19-2010 03:03 PM

Yeah...I noticed that. I'd find a set I liked and transfer the measurements to the fender cut area, you'd match the arc line of the flare, then cut. You'd just raise the bottom of the fender opening up a bit with the same profile.


All times are GMT -4. The time now is 07:02 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
vB.Sponsors
= Copyright RamForumZ.com a Gigathreads.com Network Site =Ad Management by RedTyger