DODGE RAM FORUM - Ram Forums and Owners Club! - Dodge Truck Forum

DODGE RAM FORUM - Ram Forums and Owners Club! - Dodge Truck Forum (http://www.ramforumz.com/index.php)
-   Custom Dodge Ram Interior and Exterior Lighting (http://www.ramforumz.com/forumdisplay.php?f=78)
-   -   Having trouble with my driver side low beam (http://www.ramforumz.com/showthread.php?t=74447)

SapperRam1500 02-15-2011 02:48 PM

Having trouble with my driver side low beam
 
The driver side low beam on my projector headlights went out. I replaced the bulb and it worked for less than a day. I troubleshot everything i could think of and came up empty handed. I upgraded to HID projector headlight assemblies and still no driver side low beam. Its not the assembly or the bulb. I cannot find the fuse or the relay cause there is not one labeled on the fuse box....can someone give me any helpful advice...

Diesel5182 02-15-2011 02:58 PM

maybe a ground problem?

RamTech 02-15-2011 03:06 PM

The low beam high side driver is built into the TIPMCGW and there is no serviceable fuse or relay. If you aren't getting voltage to the light with low beams selected, your TIPMCGW is probably bad and will need replacing. Of course you could always wire in a relay to power the left low beam and use the right side low beam wire to turn on the relay.

Extra Arm 02-15-2011 09:10 PM

If you had a burnt bulb you may just need a code cleared.
If there is a burnt bulb the TIPM senses this and shuts off voltage to that bulb until the bulb is changed and the code is cleared. You can try disconnecting the battery and touching the two cables together, or take it into a shop and have them clear it.


All times are GMT -4. The time now is 01:16 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
vB.Sponsors
= Copyright RamForumZ.com a Gigathreads.com Network Site =Ad Management by RedTyger