DODGE RAM FORUM - Ram Forums and Owners Club! - Dodge Truck Forum

DODGE RAM FORUM - Ram Forums and Owners Club! - Dodge Truck Forum (http://www.ramforumz.com/index.php)
-   Suspension (http://www.ramforumz.com/forumdisplay.php?f=168)
-   -   front hub assembly (http://www.ramforumz.com/showthread.php?t=78556)

jerbo 03-29-2011 05:40 PM

front hub assembly
 
hello all i am new to this site so i am hoping someone can tell me the best way to remove the front hub assembly on my 1 ton 4x4 dodge u joint r bad.

RamTech 03-29-2011 06:42 PM

A heavy duty hub puller, a BFH, and some blood, sweat, tears and swearing.

Pacheco911 05-06-2013 02:31 AM

Big hammer, pb plaster, and lots of flathead screwdrivers.

Warlock III 05-06-2013 10:08 AM

The one ton (95 if that's the one you're working on, this is the 1st gen section) should be held in with 4 bolts:

https://w05.dealerconnect.chrysler.c...S/80e1f156.gif

Remove the cotter pin and axle nut (1 1/6 nut I think or like 34mm)

Jack the truck up and take off the tire and caliper.

Remove the 4 bolts from the back of the hub and bearing.

Sometimes the bearing comes out with a few taps, sometimes it cost your first-born son.

After you get the bearing out the axle'l slide right out.


All times are GMT -4. The time now is 11:01 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
vB.Sponsors
= Copyright RamForumZ.com a Gigathreads.com Network Site =Ad Management by RedTyger