- - lift question
||03-30-2011 12:38 AM
I plan to fab my own lift blocks. does anyone know the ratio of inches to actual lift in the front end if adding spacer to struts? How high can i go this way before causing problems? was planning on going 3" front and 1.5" rear but wouldn't mind going higher. Any feedback is much appreciated!
||03-30-2011 08:02 AM
I used strut spacers on my 06 1500 quad cab. The rings were 1" thick and pre-stressed the strut for about 2" of lift. If I were going to go higher than that, I think I'd go with a different lift method to avoid front end trouble. Good luck.
|All times are GMT -4. The time now is 12:10 AM.
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
= Copyright RamForumZ.com a Gigathreads.com Network Site =Ad Management by RedTyger