ok getting ready to change the fronhubs on my truck, auto zone guy told me the axlenut socket i needed is 36 mm . is this correct ?,or would it be 1 11/16 , as ive seen someonen mention this on here. Is it safe or a good idea to put anti seeze on the axle spline before i install the hub on the axle shaft, i just had the u joints replaced a couple of months ago , so the hubs shouldnt be that hard to remove , i hope.
4x4 correct ? I can't remember the axle nut size , but antiseize is always good to use .
yes 4x4 1999 quad cab sport
|All times are GMT -4. The time now is 05:09 PM.|
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2015, vBulletin Solutions, Inc.
= Copyright RamForumZ.com a Gigathreads.com Network Site =Ad Management by RedTyger