DODGE RAM FORUM - Ram Forums and Owners Club! - Dodge Truck Forum

DODGE RAM FORUM - Ram Forums and Owners Club! - Dodge Truck Forum (http://www.ramforumz.com/index.php)
-   Body & Interior (http://www.ramforumz.com/forumdisplay.php?f=200)
-   -   Radio removal (http://www.ramforumz.com/showthread.php?t=81154)

wildbill 04-26-2011 12:50 PM

Radio removal
 
I have been unable to locate instructions as to the procedure for removing radio trim pieces in my 2010 dodge ram. I have ordered a uconnect kit which I will have no problem installing if I could only figure out how to remove radio trim. My truck has 40/20/40 seating. Thanks.

RedRam10 04-27-2011 12:21 AM

I don't have the procedure, however am interested in your Uconnect Kit installation. Hopefully someone will get some answers for you soon.

Also a warm Welcome from the North Carolina - drop in the the Newbie Checkin to introduce yourself.

brad12kx 04-27-2011 01:20 AM

NOTE: For REQ radios, turn ignition to RUN and press the SET + SCAN buttons simultaneously to place the radio into transportation mode. The radio will display "Transportation" on the display within 5 seconds. If the radio is inoperative or not REQ, skip this step.

1. Disconnect and isolate the negative battery cable.

2. Remove the upper and lower center bezel tray liners (1).

http://i900.photobucket.com/albums/a...R1-1422308.jpg

http://i900.photobucket.com/albums/a...R2-1422328.jpg






3. Using a trim stick C-4755 or equivalent, disengage the retaine clips that secure the power outlet trim bezel (1) to the center bezel (2).

http://i900.photobucket.com/albums/a...R3-1422037.jpg






4. Remove the five center bezel fastners(1).

http://i900.photobucket.com/albums/a...R4-1422346.jpg

http://i900.photobucket.com/albums/a...R5-1422356.jpg

http://i900.photobucket.com/albums/a...R6-1422370.jpg






5. Using a trim stick C-4755 or equivalent, disengage the retainer clips that secure the trim ring (1) to the floor console.

http://i900.photobucket.com/albums/a...R7-1380999.jpg






6. Using a trim stick C-4755 or equivalent, disengage the retainer clips that secure the shifter bezel (1) to the floor console

http://i900.photobucket.com/albums/a...R8-1381008.jpg






7. Using a trim stick C-4755 or equivalent, disengage the retainer clips that secure the instrument panel center bezel (1) to the instrument panel.
8. Disconnect the wire harness connectors (4) and remove the center bezel from the vehicle.

http://i900.photobucket.com/albums/a...R9-1422410.jpg








9. Remove the radio mounting fasteners.

CAUTION: Pulling the antenna cable straight out of the radio without pulling on the locking antenna connector could damage the cable or radio.

10. Disconnect the antenna cable(s) by pulling the locking antenna connector away from the radio.
11. Disconnect the electrical connectors.

http://i900.photobucket.com/albums/a...R10-108106.jpg

jbryan2 04-27-2011 01:39 AM

Check this link out step by step instructions http://www.pro-fit-intl.com/Adobe/DG-92-08-G3-p9.pdf

RBPPowerWagon 06-10-2011 01:15 PM

amazing walk throughs


All times are GMT -4. The time now is 04:44 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
vB.Sponsors
= Copyright RamForumZ.com a Gigathreads.com Network Site =Ad Management by RedTyger