DODGE RAM FORUM - Ram Forums & Owners Club! - Ram Truck Forum

DODGE RAM FORUM - Ram Forums & Owners Club! - Ram Truck Forum (
-   Custom Dodge Ram Performance Mods - Engine - 5.7 HEMI V8 (
-   -   Ram Air Project (

xtremedurb00 07-17-2011 11:04 PM

Ram Air Project
I've been thinking about this for awhile now. What I want to do is remove the intake silencer coming off the air box and get some 3" exhaust piping and bend it straight down to the passenger side fog light. About half way down that tube, I will 45 it off and run a separate pipe over to the driver side fog light. At the end of each run, I'm going to flare the pipe from 3" to about 5"s. What do you all think of this or should I just stick with one pipe? I started hanging and bending some pieces to see how it will all fit and it will work out perfectly. And then after I'm done, I plan on getting it powder coated. Let me know of any thoughts or ideas you might have on this...

chefred112 07-17-2011 11:33 PM

great ideas...I use to run mine to the fog lights...

RedRam10 07-17-2011 11:49 PM

Post some pics as you go, you know what they say:


xtremedurb00 07-18-2011 06:49 PM

I will, Ill probably start it again next week because this week is supposed to be around 100 degrees all week. Ill be sure to take plenty of pictures.

xtremedurb00 07-19-2011 08:53 PM

Scratch the 3", I'm going with 4":gr_grin: and Ill run it the same except I think I am going to aim them down at a 45 degree angle towards the ground. I already bought the 4" and have everything measured out, I just have to take it to the city to get a diesel shop to bend the tubing and swell some ends for me. Hopefully next week I will have some pics up for you all.

Pull Ya 07-20-2011 11:56 PM

I think this is about the same thing, except this is for a Cummins. PSM Intakes

All times are GMT -4. The time now is 09:24 PM.

Powered by vBulletin® Version 3.8.10
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
Copyright © VerticalScope Inc. All rights reserved.