DODGE RAM FORUM - Ram Forums and Owners Club! - Dodge Truck Forum

DODGE RAM FORUM - Ram Forums and Owners Club! - Dodge Truck Forum (http://www.ramforumz.com/index.php)
-   Exhaust (http://www.ramforumz.com/forumdisplay.php?f=146)
-   -   Impending FlowMaster 40 Install- piping question (http://www.ramforumz.com/showthread.php?t=94539)

IllestRide 10-18-2011 01:05 AM

Impending FlowMaster 40 Install- piping question
 
Morning Gents,

I'm looking to swap out my stock muffler (def on it's way out) with a Flowmaster Super 44. Currently, the exhaust piping goes from the muffler, over the read axle, and the tip is behind the rear wheel.

I'm wondering, since I'm replacing my 34-inch stock muffler with the Flowmaster (only ~19 inches), would I reduce significant back pressure by having the exhaust tip come out before the rear wheel (getting rid of a few bends in the process)?

Anyone try this? There doesn't seem to be a whole lot of info on this idea from my research.

Also, would there be any reason that I wouldn't be able to install the Super 44? I've matched up the piping diameter (2.5") and also the inlet/outlet placements (diagonally offset). Wondering if anything else would prohibit this being done?


Thanks in advance, happy Tuesday.

shujat 10-20-2011 05:07 PM

bump for the good question, I hope someone can help!


All times are GMT -4. The time now is 09:40 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
vB.Sponsors
= Copyright RamForumZ.com a Gigathreads.com Network Site =Ad Management by RedTyger