DODGE RAM FORUM - Ram Forums and Owners Club! - Dodge Truck Forum

Go Back   DODGE RAM FORUM - Ram Forums and Owners Club! - Dodge Truck Forum > Search Forums


Notices


Latest Vendor News
AutoAnything
Addictive Desert Designs!
Bayou Goat Mounts

Showing results 1 to 25 of 44
Search took 0.01 seconds.
Search: Posts Made By: Kruzer
Forum: 5.9L V8 Specific Topics 05-14-2012, 09:31 PM
Replies: 10
Views: 1,046
Posted By Kruzer
Glad you saw something obvious, that always makes...

Glad you saw something obvious, that always makes you feel better... :smileup:
Forum: Electrical 04-29-2012, 09:17 PM
Replies: 13
Views: 942
Posted By Kruzer
Yep, you definitely let the smoke out... well at...

Yep, you definitely let the smoke out... well at least you know what it is now.
Forum: 5.7L V8 Specific Topics 04-28-2012, 11:40 PM
Replies: 35
Views: 1,763
Posted By Kruzer
Slid the retaining clip out, remove injector. ...

Slid the retaining clip out, remove injector. Grease (just a small amount) up the new and old injector o'rings, reinstall. That's pretty much it, try not to let anything fall in the injector...
Forum: Electrical 04-27-2012, 09:00 PM
Replies: 13
Views: 942
Posted By Kruzer
Did you do a continuity check on the switches to...

Did you do a continuity check on the switches to see if they were working? In my experience I would lean toward one of the resistor before a switch. Switches usually are pretty hardy critters, I'm...
Forum: 5.7L V8 Specific Topics 04-26-2012, 11:50 PM
Replies: 16
Views: 3,429
Posted By Kruzer
Warlock III, it's all good, and I hope I did not...

Warlock III, it's all good, and I hope I did not make it sound like I was trying upstage you in anyway. I just know from experience that if the tanks vent system is jacked up you will get the fuel...
Forum: 5.7L V8 Specific Topics 04-26-2012, 08:15 PM
Replies: 16
Views: 3,429
Posted By Kruzer
This is the exact problem I was talking about. ...

This is the exact problem I was talking about. The rollover valve only comes into play if the vehicle is turned over. This valve is actually made into the tank itself and looks like a small gage...
Forum: Electrical 04-26-2012, 07:19 PM
Replies: 13
Views: 942
Posted By Kruzer
I don't believe there are any other power...

I don't believe there are any other power modules/fuse centers for your truck. The TIPM pretty much supplies all the power needs for the vehicle. If a circuit is open (damaged) it should have a...
Forum: 5.9L V8 Specific Topics 04-26-2012, 07:05 PM
Replies: 10
Views: 1,046
Posted By Kruzer
More things to check.

As Warlock III said there are bushings in the distributor housing itself, but the one I am referring to is mounted in the block. There is a Mopar tool to Knurl the bushing to take up the slack...
Forum: 5.7L V8 Specific Topics 04-26-2012, 06:45 PM
Replies: 35
Views: 1,763
Posted By Kruzer
No problem, pretty much everything else is inside...

No problem, pretty much everything else is inside the trans. Good luck.
Forum: Electrical 04-25-2012, 11:08 PM
Replies: 13
Views: 942
Posted By Kruzer
The PDC or TIPM is where the fuses are under the...

The PDC or TIPM is where the fuses are under the hood, that regtangular box with all the wires coming out of it. Now I guess your next step is a scan tool to check for any codes.
Forum: 2012 Dodge Ram Forum 04-25-2012, 09:10 PM
Replies: 5
Views: 468
Posted By Kruzer
Hey, it never hurts to drop off some food... I...

Hey, it never hurts to drop off some food... I know I always loved it when customers brought in some goodies!!! It will definitely help you out in the long run, glad you got your baby back. I know...
Forum: Suspension 04-25-2012, 09:02 PM
Replies: 1
Views: 348
Posted By Kruzer
If the noise started after you repalced the...

If the noise started after you repalced the shocks then that's where I would start first. Can you bounce the truck and get the noise to be heard, get a friend to bounce it for you while you crawl...
Forum: 5.9L V8 Specific Topics 04-25-2012, 08:54 PM
Replies: 10
Views: 1,046
Posted By Kruzer
From your symptom if I were a betting man I would...

From your symptom if I were a betting man I would say you are on the right track with the intake manifold gasket replacement. The only other problem and your miles could also lead to this, is the...
Forum: 5.7L V8 Specific Topics 04-25-2012, 08:22 PM
Replies: 16
Views: 3,429
Posted By Kruzer
If the pump is not shutting off then it is the...

If the pump is not shutting off then it is the gas pump at fault, but if the pump is shutting off but gas spills out after it shuts off then your truck has a problem. When the later happens it means...
Forum: 2010 Dodge Ram Forum 04-25-2012, 08:11 PM
Replies: 2
Views: 508
Posted By Kruzer
If your truck came with the trailer brake wiring...

If your truck came with the trailer brake wiring option then it should have came with the blue connector pig tail in your glove box. The under the dash harness plug is located by the emergency brake...
Forum: Electrical 04-25-2012, 03:18 PM
Replies: 13
Views: 942
Posted By Kruzer
No circuit breakers under the dash that I am...

No circuit breakers under the dash that I am aware of...
Forum: Electrical 04-25-2012, 01:59 PM
Replies: 13
Views: 942
Posted By Kruzer
Without looking at the schematic and what/how you...

Without looking at the schematic and what/how you tapped into the wiring, it will be a tough one to figure out. The PDC (Power Distribution Center) should actually be a module, and does have some...
Forum: 5.7L V8 Specific Topics 04-25-2012, 01:08 PM
Replies: 35
Views: 1,763
Posted By Kruzer
Both input and output speed sensors are on the...

Both input and output speed sensors are on the left side of the transmission. Input will be toward the front close to the bell housing and the output will be close to the tail shaft housing. Should...
Forum: 5.7L V8 Specific Topics 04-24-2012, 04:38 PM
Replies: 35
Views: 1,763
Posted By Kruzer
#2 is the right (passenger side) front cylinder. ...

#2 is the right (passenger side) front cylinder. You could always pull the speed sensors out and check to see if they are covered with trans material and clean them if they are.
Forum: 5.7L V8 Specific Topics 04-23-2012, 02:00 PM
Replies: 35
Views: 1,763
Posted By Kruzer
I don't know that for sure, it could be a sensor...

I don't know that for sure, it could be a sensor or an internal part on the valve body and it could be a simple fix.... It may not be slipping but the information the TCM is receiving caused the...
Forum: 5.7L V8 Specific Topics 04-23-2012, 12:06 AM
Replies: 35
Views: 1,763
Posted By Kruzer
Your trans has an input speed sensor and an...

Your trans has an input speed sensor and an output speed sensor. One of the uses for these sensors is to determine if the trans is slipping. The error you received is more than likely due to some...
Forum: 5.7L V8 Specific Topics 04-22-2012, 11:12 PM
Replies: 35
Views: 1,763
Posted By Kruzer
Like I said previously, once you have both fuel...

Like I said previously, once you have both fuel rails removed, just turn the key on an off a couple of times allowing the fuel pump to cycle each time, then watch for drips. If you aren't seeing...
Forum: 5.7L V8 Specific Topics 04-22-2012, 09:40 PM
Replies: 35
Views: 1,763
Posted By Kruzer
The injectors are not hard to get to. Once you...

The injectors are not hard to get to. Once you remove the engine cover you will be able to see them. There should be 4 bolts that hold the injector rails down, two on each side of the intake. ...
Forum: 5.7L V8 Specific Topics 04-22-2012, 01:27 AM
Replies: 35
Views: 1,763
Posted By Kruzer
What Giddyup states is very possible, the one...

What Giddyup states is very possible, the one thing that didn't clue into this was you said after sitting over night it would start right up. Usually a telltale sign of injectors leaking is long...
Forum: 5.7L V8 Specific Topics 04-20-2012, 09:57 PM
Replies: 35
Views: 1,763
Posted By Kruzer
Like GTyankee says, it is a generic code to tell...

Like GTyankee says, it is a generic code to tell you to examine the TCM (Transmission Control Module). I'm trying to remember if the 2005 has a stand alone TCM, in any case you need a scanner that...
Showing results 1 to 25 of 44

 
Forum Jump


Advertisement






All times are GMT -4. The time now is 04:05 PM.


= Copyright RamForumZ.com a Gigathreads.com Network Site =Ad Management by RedTyger
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2015, vBulletin Solutions, Inc.
vB.Sponsors


=Gigathreads Network=
CLUBS MOPAR NATION DSM GPMM MAMM JAM
DIESEL Diesel Forum      
CHEVY Chevy Camaro Forum Chevy Volt Forum    
CHRYSLER Chrysler 300C Forum      
DODGE Dodge Avenger Forum Dodge Caliber Forum Dodge Challenger Forum Dodge Charger Forum
  Dodge Circuit Forum Dodge Hornet Forum Dodge Magnum Forum Dodge Nitro Forum
  Dodge Ram Forum Dodge Dakota Forum Dodge Durango Forum Dodge Dart Forum
FORD Ford Raptor Forum Ford F150 Forum Ford F100 Forum  
JEEP Jeep Forum      
PONTIAC Pontiac G8 Forum      
SRT SRT Viper Forum SRT Cuda Forum