DODGE RAM FORUM - Ram Forums & Owners Club! - Ram Truck Forum - Search Results
DODGE RAM FORUM - Ram Forums & Owners Club! - Ram Truck Forum

Go Back   DODGE RAM FORUM - Ram Forums & Owners Club! - Ram Truck Forum > Search Forums

Dodge Dakota Dodge Durango Dodge Nitro Jeep
Diesel Forums!
Dodge Dakota Forum Dodge Durango Forum Dodge Nitro Forum Jeep Forum
Dodge Challenger Dodge Charger Chrysler 300 Dodge Magnum
Dodge Caliber
Dodge Challenger Forum Dodge Charger Forum Chrysler 300 Forum Dodge Magnum Forum


Notices


Vendor Highlight! - Check these guys out for great deals on Parts and Accessories!
Place your Ad Here!

Showing results 1 to 25 of 200
Search took 0.01 seconds.
Search: Posts Made By: hpc3
Forum: LD RAM - General Discussion 07-21-2013, 03:02 PM
Replies: 0
Views: 249
Posted By hpc3
'10 Laramie - key/ignition module markings from factory?

Question for the Gen4 remote start owner base... my truck turned 3yrs old last month and just like clockwork has a remote/unlock issue that has manifested. In particular the truck will not unlock...
Forum: 2010 Dodge Ram Forum 11-12-2011, 01:00 AM
Replies: 40
Views: 8,592
Posted By hpc3
I don't believe this is the case with the shift patterns on the '10 545RFEs...

Although the gear ratios are the same there is no difference in normal driving between tow/haul and normal operation on mine. The trans in 2WD uses the following pattern(that I really hate with a...
Forum: 2010 Dodge Ram Forum 01-09-2011, 01:18 PM
Replies: 6
Views: 1,469
Posted By hpc3
I'm running the 3.5" Infiniti Kappa 2ohms in mine...

They fit and sound *much* better than the stockers. I originally wanted to replace the center dash and two headliner tweeters but have left them alone due to odd sizing. Just replacing the outboard...
Forum: 5.7L V8 Specific Topics 12-20-2010, 12:30 AM
Replies: 6
Views: 2,307
Posted By hpc3
Mine works(sometimes)... think this is more of a UConnect issue:

The truck is finicky with the Bluetooth in general, I had little glitches with my Blackberry Bold9000 as well. One thing I learned is you have to let the NAB load before you can try to make a call......
Forum: Custom Chassis - Drive Line - Suspension - Wheels and Tires - LIFTING - Dodge Ram 4x4, 2x4 12-19-2010, 11:23 PM
Replies: 20
Views: 4,878
Posted By hpc3
Well...

I'm mostly happy with the setup in the 4th clip. Honestly I'd really like to have gone the extra ~0.5" on the fronts to do a complete level and have it match the rear but the minute I put my...
Forum: Custom Chassis - Drive Line - Suspension - Wheels and Tires - LIFTING - Dodge Ram 4x4, 2x4 12-17-2010, 09:00 AM
Replies: 65
Views: 39,536
Posted By hpc3
Sorry, my spam filter was blocking...

if anyone still has questions for me or my setup (Bilsteins, BFG KOs) please let me know. Happy to help.

My apologies.
Forum: Custom Chassis - Drive Line - Suspension - Wheels and Tires - LIFTING - Dodge Ram 4x4, 2x4 09-18-2010, 10:07 AM
Replies: 65
Views: 39,536
Posted By hpc3
Thank you...

Here's a better pic, all finished up:

http://web.comporium.net/~hpc3/pics/NewRam/RamLift4.jpg


Still figuring out my camera... was trying to capture the sun "popping" on the Inferno Red at the...
Forum: Custom Chassis - Drive Line - Suspension - Wheels and Tires - LIFTING - Dodge Ram 4x4, 2x4 09-13-2010, 05:59 PM
Replies: 13
Views: 8,459
Posted By hpc3
Update: installed Bilsteins and they work w/o shudder

I installed the leveling shocks/struts and they work fine and don't cost a bunch either(TireRack has them for ~$350/4). Personally I'd skip the spacers now that this setup is available for...
Forum: Custom Chassis - Drive Line - Suspension - Wheels and Tires - LIFTING - Dodge Ram 4x4, 2x4 09-05-2010, 10:22 AM
Replies: 35
Views: 14,752
Posted By hpc3
Wow, thanks for the compliment.

I'll read up on the calendar thread. Appreciate it.
Forum: Custom Chassis - Drive Line - Suspension - Wheels and Tires - LIFTING - Dodge Ram 4x4, 2x4 09-04-2010, 09:13 PM
Replies: 35
Views: 14,752
Posted By hpc3
Forgot to post... heres mine with the Bilsteins on in 4th position(2.1"+)

I wanted to keep a slight rake to the truck. There is a 5th position at 2.8"+ level/lift on the front but it would have put it dead even with the stock rear height. 305/55/20 BFG KOs on as well. Good...
Forum: Custom Chassis - Drive Line - Suspension - Wheels and Tires - LIFTING - Dodge Ram 4x4, 2x4 08-29-2010, 11:21 AM
Replies: 65
Views: 39,536
Posted By hpc3
Tires and Bilsteins on, 4th clip setting at 2.1"+ height

instead of all the way up which would have leveled it exactly(2.8" setting). I left a little bit of rake in it because I do tow some and not interested in raising the rear or bagging at this time. I...
Forum: Custom Chassis - Drive Line - Suspension - Wheels and Tires - LIFTING - Dodge Ram 4x4, 2x4 08-27-2010, 12:19 AM
Replies: 65
Views: 39,536
Posted By hpc3
Wish me luck. I'm getting 305/55/20 BFG KOs...

Wish me luck. I'm getting 305/55/20 BFG KOs mounted tomorrow. I'm 90% road driven here and the guys at Discount Tire tell me the Trails are good but will get louder as they wear(which I think is...
Forum: 2010 Dodge Ram Forum 08-27-2010, 12:03 AM
Replies: 10
Views: 4,099
Posted By hpc3
Mine mostly works although still has some little

Quirks. I have a RER and iPhone 4 running IOs4.02 fwiw.

The only recommendation I'll offer is to ALWAYS use the uConnect voice control functions to use the phone through bluetooth. If you use the...
Forum: 2010 Dodge Ram Forum 08-18-2010, 10:48 AM
Replies: 31
Views: 6,769
Posted By hpc3
Thanks for the pics. I guess I better get off my rear and install my Bilsteins

that have been sitting in the corner of the garage now for a few weeks.
Forum: Custom Dodge Ram Performance Mods - Engine - 5.7 HEMI V8 08-16-2010, 12:06 AM
Replies: 11
Views: 3,277
Posted By hpc3
Flash update note?

Probably a flash update to the ECU. This is common on the 6.7 Cummins, I got a flash at just about every service on my 2500, flash revision was always a hand written note on the radiator cross-member.
Forum: 2010 Dodge Ram Forum 08-15-2010, 12:08 PM
Replies: 31
Views: 6,769
Posted By hpc3
Thanks for the measurements... I have been looking at my

Bilsteins sitting in the corner of my garage wondering if I should do the 4th or 5th clip on installation for my Laramie(I have an a-frame spring compressor but hate fighting with it so...). I'm...
Forum: 2010 Dodge Ram Forum 08-06-2010, 07:46 AM
Replies: 19
Views: 2,275
Posted By hpc3
LOL with Brad...

I can't confirm the mileage yet but just seeing the EVIC a few points higher(and the truck driving like a "normal" V8 now) makes me feel much better heh.
Forum: 2010 Dodge Ram Forum 08-05-2010, 09:39 PM
Replies: 19
Views: 2,275
Posted By hpc3
Heh, ironic...

I disabled mine last week and ... EVIC says "15.2mpg" of putting around town mileage. I haven't confirmed it but will at next fill-up. FYI thats about 2.5mpg better than mine with MDS enabled.
...
Forum: Custom Chassis - Drive Line - Suspension - Wheels and Tires - LIFTING - Dodge Ram 4x4, 2x4 08-02-2010, 12:05 PM
Replies: 65
Views: 39,536
Posted By hpc3
Get some UniSolve from a medical supply/nursing store to cut the goo off.

Its what they use to remove IV bandages and other skin/bandaid goo in the hospitals... it will take the Mopar/3M adhesive off in a few applications and not affect the paint either. I've used it on...
Forum: Custom Dodge Ram Interior and Exterior Lighting 08-02-2010, 11:54 AM
Replies: 16
Views: 6,219
Posted By hpc3
Jeremy do you have part numbers on these?

... also what shrouds you used?

Any idea if these used ones are a sign of things to come after some use/mileage(or sign of a sloppy install)? Thanks again for the post.
Forum: Custom Dodge Ram Interior and Exterior Lighting 08-01-2010, 10:39 PM
Replies: 16
Views: 6,219
Posted By hpc3
Wow, nicely done... I almost wish I hadn't read...

Wow, nicely done... I almost wish I hadn't read this. D@mnD@mnD@mn i don't want any more mods until I get my shocks/lift/tires done. And now maybe lights ugh!

Very nice.
Forum: Custom Chassis - Drive Line - Suspension - Wheels and Tires - LIFTING - Dodge Ram 4x4, 2x4 08-01-2010, 10:27 PM
Replies: 7
Views: 2,002
Posted By hpc3
Well, I've gone a different route now... Bilsteins.

I have a set of leveling shocks/struts(all 4 based on the 5100 cartridges) coming for the front and the matching rears with 1" additional travel on the way. Initially I'd planned on using slot 4 of 5...
Forum: Exhaust 07-29-2010, 10:34 PM
Replies: 10
Views: 1,511
Posted By hpc3
...or get the loud setup, and a tuner to disable MDS and

go intimidating lol.

My Magnaflow with tips is quiet while cruising but pretty rowdy with the pedal down. I'm never going to get any mileage with this setup... =)
Forum: Custom Dodge Ram Performance Mods - Engine - 5.7 HEMI V8 07-24-2010, 11:02 AM
Replies: 11
Views: 1,626
Posted By hpc3
Unless you have a brother with a machine shop

or build engines for a living I'd go crate. There are so many specs and values(and tricks) even today with the engines that unless you're a builder or know someone that is(and you can trust) your...
Forum: 2010 Dodge Ram Forum 07-22-2010, 07:21 PM
Replies: 1
Views: 606
Posted By hpc3
My console rattle is back in full force...

this chrome trim surround is pretty dumb in inplementation. Its been really hot here(like almost 100 deg daily hot) and the surround ring keeps coming loose at the front driver's edge. I'll piddle...
Showing results 1 to 25 of 200

 
Forum Jump


Advertisement








All times are GMT -4. The time now is 02:08 PM.


= Copyright RamForumZ.com a Gigathreads.com Network Site =Ad Management by RedTyger
Powered by vBulletin® Version 3.8.10
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
vB.Sponsors