DODGE RAM FORUM - Ram Forums and Owners Club! - Dodge Truck Forum

Go Back   DODGE RAM FORUM - Ram Forums and Owners Club! - Dodge Truck Forum > Search Forums
Register Advertising Gallery FAQ Members List Calendar Search Today's Posts Mark Forums Read


Notices


Latest Vendor News
AutoAnything
Addictive Desert Designs!
Bayou Goat Mounts

Showing results 1 to 25 of 500
Search took 0.56 seconds.
Search: Posts Made By: RamTech
Forum: Heating & Cooling Yesterday, 03:34 PM
Replies: 1
Views: 25
Posted By RamTech
Sounds like an ignition switch problem. Remove...

Sounds like an ignition switch problem. Remove the steering column shrouds, unplug the switch connector and see if it's burnt.
Forum: 2014 Dodge Ram Forum Yesterday, 11:09 AM
Replies: 4
Views: 96
Posted By RamTech
- Yes, you can use RP. - The front holds 2.3...

- Yes, you can use RP.
- The front holds 2.3 pints and the rear holds 4.4 pints if you have the LSD option.
- Limited-Slip Rear Axles require the addition of (4 oz.) MOPAR® Limited Slip Additive.
Forum: 3.7L PowerTech V6 Specific Topics Yesterday, 08:53 AM
Replies: 1
Views: 25
Posted By RamTech
You need a scan tool capable of pulling the codes...

You need a scan tool capable of pulling the codes that are in the PCM, for starters. A fuel pump issue isn't going to throw an ETC code, but that's not to say you couldn't also have a pump related...
Forum: 5.9L V8 Specific Topics Yesterday, 08:12 AM
Replies: 10
Views: 166
Posted By RamTech
A leak down test will tell you what percentage of...

A leak down test will tell you what percentage of air is escaping the cylinder and where it's going. Once the tester is hooked up and you verify a compression loss of greater than 25% or so, check to...
Forum: 2009 Dodge Ram Forum Yesterday, 08:07 AM
Replies: 6
Views: 69
Posted By RamTech
The entire dash gets pulled and then the HVAC box...

The entire dash gets pulled and then the HVAC box is removed and the evaporator gets replaced. You might want to consider replacing the heater core too, if there's any doubt it's less than 100%.
Forum: 4th Gen UConnect 07-24-2015, 04:58 PM
Replies: 11
Views: 187
Posted By RamTech
I'd love to see that happen, but that decision is...

I'd love to see that happen, but that decision is above my pay grade.
Forum: 2016 Dodge Ram Forum 07-24-2015, 04:19 PM
Replies: 14
Views: 283
Posted By RamTech
I can't get any info from an order number. I can...

I can't get any info from an order number. I can only work with the VIN.
Forum: 2009 Dodge Ram Forum 07-24-2015, 02:59 PM
Replies: 6
Views: 69
Posted By RamTech
Those are the only two relays for that fan. I'm...

Those are the only two relays for that fan. I'm wondering if the A/C pressure transducer is working. If it's reading too low, it won't turn on the fan. Plus I'd want to know the actual high and low...
Forum: Electrical 07-24-2015, 02:56 PM
Replies: 10
Views: 99
Posted By RamTech
Well, we have another possibility, anyway. I make...

Well, we have another possibility, anyway. I make no guarantees...lol.
Forum: 4th Gen UConnect 07-24-2015, 02:55 PM
Replies: 11
Views: 187
Posted By RamTech
Personally, I think we have too many sections. I...

Personally, I think we have too many sections. I can't possibly keep up with all the help requests unless they're specifically in my section.
Forum: Electrical 07-24-2015, 02:13 PM
Replies: 10
Views: 99
Posted By RamTech
Yes, it can, and I've seen more than one harness...

Yes, it can, and I've seen more than one harness pinched by a gooseneck plate.
Forum: 2009 Dodge Ram Forum 07-24-2015, 02:01 PM
Replies: 6
Views: 69
Posted By RamTech
How did you check the relays and did you have...

How did you check the relays and did you have power on the 85 and 87 terminals with the key on? 86 should be an open circuit until the fans are commanded on and then they should have continuity to...
Forum: Electrical 07-24-2015, 01:52 PM
Replies: 10
Views: 99
Posted By RamTech
Sometimes it's visible, sometimes not. He may...

Sometimes it's visible, sometimes not. He may have to open the harness.
Forum: Electrical 07-24-2015, 11:57 AM
Replies: 10
Views: 99
Posted By RamTech
Sure, it's possible there could be a short to...

Sure, it's possible there could be a short to power on that circuit. Remove fuse 53 from the box and if the light is still on, you definitely have a short to power somewhere. If it goes out, that...
Forum: 2016 Dodge Ram Forum 07-24-2015, 08:24 AM
Replies: 14
Views: 283
Posted By RamTech
No, that was for the VIN DJV22 posted, not the...

No, that was for the VIN DJV22 posted, not the order number from the OP.
Forum: 2016 Dodge Ram Forum 07-23-2015, 03:33 PM
Replies: 14
Views: 283
Posted By RamTech
Your VIN came back as a 1986 model for some...

Your VIN came back as a 1986 model for some reason.
Forum: Custom Dodge Ram Performance Mods - Engine - 4.7 Liter V8 07-23-2015, 02:17 PM
Replies: 2
Views: 46
Posted By RamTech
Hornet is right. More money is wasted on TB...

Hornet is right. More money is wasted on TB spacers and miracle sensors that allegedly offer 40+ HP gains than anything else I've ever seen.
Forum: 4.7L PowerTech V8 Specific Topics 07-23-2015, 02:16 PM
Replies: 1
Views: 27
Posted By RamTech
You're both right.

You're both right.
Forum: 4th Gen UConnect 07-23-2015, 12:52 PM
Replies: 11
Views: 187
Posted By RamTech
Oh, I know you weren't. I just didn't want anyone...

Oh, I know you weren't. I just didn't want anyone getting the wrong idea from it.
Forum: Dodge Ram Recalls and TSB's. 07-23-2015, 12:45 PM
Replies: 9
Views: 196
Posted By RamTech
Chrysler recommends using IE for their stuff....

Chrysler recommends using IE for their stuff. Chrome works most of the time, but does have an occasional problem or two.
Forum: Dodge Ram Recalls and TSB's. 07-23-2015, 12:12 PM
Replies: 9
Views: 196
Posted By RamTech
This update doesn't apply to your truck since you...

This update doesn't apply to your truck since you don't have the RA3 or RA4 radio.
Forum: 2016 Dodge Ram Forum 07-23-2015, 12:04 PM
Replies: 14
Views: 283
Posted By RamTech
I can check if you give me the last 8 characters...

I can check if you give me the last 8 characters of the VIN.
Forum: 4th Gen UConnect 07-23-2015, 11:33 AM
Replies: 11
Views: 187
Posted By RamTech
Not everyone has time to perform a thorough...

Not everyone has time to perform a thorough search for similar information before posting pertinent information (namely me, because much of what I post is done while at work). The day we start...
Forum: Body & Interior 07-23-2015, 11:17 AM
Replies: 2
Views: 66
Posted By RamTech
Nope, there are no adjustments that would change...

Nope, there are no adjustments that would change this. It is what it is.
Forum: 5.7L V8 Specific Topics 07-23-2015, 10:45 AM
Replies: 4
Views: 52
Posted By RamTech
Converter Clutch status. If I were chasing this...

Converter Clutch status. If I were chasing this problem, I would test drive the truck while watching the CC status via the data stream in a scan tool when it happens. If the status changes from...
Showing results 1 to 25 of 500

 
Forum Jump


Advertisement






All times are GMT -4. The time now is 06:32 AM.


= Copyright RamForumZ.com a Gigathreads.com Network Site =Ad Management by RedTyger
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2015, vBulletin Solutions, Inc.
vB.Sponsors