DODGE RAM FORUM - Ram Forums & Owners Club! - Ram Truck Forum - Search Results
DODGE RAM FORUM - Ram Forums & Owners Club! - Ram Truck Forum

Go Back   DODGE RAM FORUM - Ram Forums & Owners Club! - Ram Truck Forum > Search Forums


Notices


Vendor Highlight! - Check these guys out for great deals on Parts and Accessories!
Showing results 1 to 25 of 59
Search took 0.01 seconds.
Search: Posts Made By: pinstripefan90
Forum: LD RAM - General Discussion 05-25-2017, 08:24 PM
Replies: 6
Views: 238
Posted By pinstripefan90
Buy a 4th gen 09 and up, I have only seen rot on...

Buy a 4th gen 09 and up, I have only seen rot on 1 so far and my 100k '12 is still mint for now
Forum: 2011 Dodge Ram Forum 05-25-2017, 08:22 PM
Replies: 12
Views: 1,399
Posted By pinstripefan90
Bring it back to the dealer that you purchased it...

Bring it back to the dealer that you purchased it from until it is fixed, I know the plugs are due roughly every 30k or so but I don't suspect them due to the fact of such low miles, it could be...
Forum: Body & Interior 04-16-2017, 08:32 AM
Replies: 14
Views: 517
Posted By pinstripefan90
What bugflector do you guys use

I know for this body style ram there are a few choices and I just wanted to see what you guys have used, I like the look of my ram without the bugflector but id like to protect the front edge of the...
Forum: 4.7L (287 cu in) PowerTech V8 Specific Topics 03-04-2017, 11:21 PM
Replies: 2
Views: 267
Posted By pinstripefan90
So, I have looked at this post a few times and I...

So, I have looked at this post a few times and I am curious how did LazyD ever make out?
Forum: 2012 Dodge Ram Forum 01-29-2017, 09:56 AM
Replies: 306
Views: 62,330
Posted By pinstripefan90
I bought my Ram used a little over a year ago,...

I bought my Ram used a little over a year ago, 2012 1500 Quad Cab 4x4 4.7 85k miles really clean for $14,000
Forum: 2009 Dodge Ram Forum 01-21-2017, 09:35 PM
Replies: 60
Views: 8,085
Posted By pinstripefan90
Cherokees (9 speeds) are a easy fix for the most...

Cherokees (9 speeds) are a easy fix for the most part, when they are messed up I have to contact Chrysler to decide the next step, which is either replace valve body and re evaluate or slam a unit in...
Forum: Rust Repair 01-20-2017, 01:54 PM
Replies: 12
Views: 3,879
Posted By pinstripefan90
I live in the rust belt and honestly, in upstate...

I live in the rust belt and honestly, in upstate ny everything rots, its just a matter of time, I work an hr plus closer to the city from my home and last week I had a 09 Ram come in with the bed rot...
Forum: 4.7L (287 cu in) PowerTech V8 Specific Topics 01-20-2017, 01:26 PM
Replies: 11
Views: 1,384
Posted By pinstripefan90
Ramboni, where did you get that air intake tube...

Ramboni, where did you get that air intake tube from, I would like to put that on my truck, thanks.

- Jake
Forum: LD RAM - General Discussion 01-20-2017, 12:24 PM
Replies: 38
Views: 1,188
Posted By pinstripefan90
There was 1 time that I washed it with soap and...

There was 1 time that I washed it with soap and water the day before I put my bed liner in, other than that I always give it a good rinse out at the end of hunting season so it doesn't look like a...
Forum: LD RAM - General Discussion 01-20-2017, 12:13 PM
Replies: 20
Views: 645
Posted By pinstripefan90
OEM bedliner with the molded Rams head is my...

OEM bedliner with the molded Rams head is my personal favorite for a drop in, it just looks legit.
Forum: Custom Dodge Ram Performance Mods - Engine - 4.7 Liter V8 01-20-2017, 11:42 AM
Replies: 14
Views: 2,375
Posted By pinstripefan90
Thanks snrusnak, I'm definitely going to look...

Thanks snrusnak, I'm definitely going to look into the superchips, any specific model from them and also do you have a preferred retailer or just shop around anywhere? Thanks again for the input. ...
Forum: 2009 Dodge Ram Forum 01-19-2017, 10:30 PM
Replies: 60
Views: 8,085
Posted By pinstripefan90
I'm with RamTech

I'm with RamTech, I'm a full certified Chrysler Tech, I wish I were lucky enough to be able to do tune-ups but being that I am the only trans tech at my dealer I'm usually tied up with a few trannies...
Forum: 2009 Dodge Ram Forum 01-19-2017, 10:19 PM
Replies: 111
Views: 14,924
Posted By pinstripefan90
I'm the 2nd owner of my truck, I now have 98k on...

I'm the 2nd owner of my truck, I now have 98k on it and other than maintenance it hasn't needed much, somewhere in the 70k mile range the trans solenoid pack was replaced and since then I have...
Forum: 2012 Dodge Ram Forum 01-19-2017, 09:59 PM
Replies: 58
Views: 9,210
Posted By pinstripefan90
At times, I leave mine at 30psi if I know I will...

At times, I leave mine at 30psi if I know I will be towing/hauling again soon plus its nice to be lazy at times but if I'm not planning on using the truck for any work I do lower it down to about...
Forum: 4.7L (287 cu in) PowerTech V8 Specific Topics 01-17-2017, 10:38 PM
Replies: 3
Views: 1,028
Posted By pinstripefan90
I did all of my plugs today at home and I did...

I did all of my plugs today at home and I did them all from the top, If I was at work typically for newer 4.7 tune ups I pull fender liners with the truck on the lift but since I did my own truck at...
Forum: Custom Dodge Ram Performance Mods - Engine - 4.7 Liter V8 01-17-2017, 10:20 PM
Replies: 49
Views: 5,707
Posted By pinstripefan90
Run the oem bosch plugs, upper plugs (intake) at...

Run the oem bosch plugs, upper plugs (intake) at .040" and the lower plugs (exhaust) at .050" - be ready for the coil boots to tear/break, napa sells boot kits, I even had a plug wire gut itself off...
Forum: Body & Interior 01-08-2017, 09:10 PM
Replies: 4
Views: 288
Posted By pinstripefan90
Well with the severe cold I jumped into my truck...

Well with the severe cold I jumped into my truck today and saw the crack instead of being about to the height of the PRNDL/odometer it is now more than half of my cluster, guess I'm going to my parts...
Forum: Dodge Ram R/T 01-08-2017, 09:05 PM
Replies: 10
Views: 623
Posted By pinstripefan90
...there is a reason that they don't offer...

...there is a reason that they don't offer lifetime warranty on ecoDiesel, too costly and too problematic
Forum: Dodge Ram R/T 01-08-2017, 09:03 PM
Replies: 5
Views: 313
Posted By pinstripefan90
I'd take it to the dealer, it may be as simple as...

I'd take it to the dealer, it may be as simple as a TCM update or you might actually have something going on, either way I would schedule an appointment sooner than later
Forum: Custom Dodge Ram Interior and Exterior Lighting 01-08-2017, 09:51 AM
Replies: 8
Views: 329
Posted By pinstripefan90
Lights came and I set them up last night, much...

Lights came and I set them up last night, much brighter than I thought they would be, a little difficult to aim based in the pattern they put out but I set them up pointing slightly outwards so I can...
Forum: Custom Dodge Ram Interior and Exterior Lighting 01-01-2017, 11:05 AM
Replies: 8
Views: 329
Posted By pinstripefan90
Yeah, I ended up ordering these:...

Yeah, I ended up ordering these: https://www.amazon.com/gp/product/B00ZR5Z3SM/ref=oh_aui_detailpage_o00_s00?ie=UTF8&psc=1 They say they are cree and someone else on the forum had them and was happy...
Forum: Suspension 12-31-2016, 08:16 PM
Replies: 9
Views: 1,581
Posted By pinstripefan90
There was a recall on shocks a few years ago and...

There was a recall on shocks a few years ago and I had the pleasure of changing quite a few and I ended up buying a 21mm offset wrench that I then cut down and made work
Forum: North East 12-31-2016, 08:13 PM
Replies: 6
Views: 512
Posted By pinstripefan90
I'm about a hour plus from albany, I leveled mine...

I'm about a hour plus from albany, I leveled mine but bought parts from the internet
Forum: Rust Repair 12-31-2016, 07:45 PM
Replies: 6
Views: 1,650
Posted By pinstripefan90
When I was younger and I started working for the...

When I was younger and I started working for the dealer I remember b/c I was the "kid" they had me clay bar an entire silver magnum due to rail dust, took lots of work but I got it off
Forum: Rust Repair 12-31-2016, 07:41 PM
Replies: 4
Views: 1,700
Posted By pinstripefan90
These things are a joke and a waste of money when...

These things are a joke and a waste of money when it comes to cars, I have worked on a number of cars that have had them and all they are good for is creating a draw, I legit worked on one that had...
Showing results 1 to 25 of 59

 
Forum Jump


Advertisement



All times are GMT -4. The time now is 06:23 PM.


Copyright © VerticalScope Inc. All rights reserved.
Powered by vBulletin® Version 3.8.10
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
vB.Sponsors