Thread: cummins blowby
View Single Post
  #2  
Old 02-28-2013, 04:22 AM
scrappy scrappy is offline
Dodge Ram Forum Senior Member!
 
Join Date: Feb 2013
Location: princeton
Age: 39
Posts: 107
Gender: Male
Vehicle: '12 ram 3500
Trim Level: laramie limited
Color: mineral grey
Engine: 2011-20?? 409ci (6.7L) Cummins Turbo Diesel 350hp 800lb/ft
Rep Power: 0
Rep:29
scrappy is on a distinguished road
Default

Quote:
Originally Posted by 95dodgeV10 View Post
Iv got an 01 cummins that between unexpectedly running very low on oil and not knowing it and very possible poor maintenance by previous owners is showing signs of wear. iv got excessive blowby or at least what i consider excessive and was wanting some input if its possibly something "easier" in the cylinder head such as valve guides or something more involved as in piston rings. Im not real familiar with the cummins yet so im not sure what we be the easiest to wipeout due to the previously listed problems. thanks for any input fingers crossed i dont feel like doing a full rebuild any time soon.
how bad is the blowby? take the oil cap off and with the engine running set the oil cap on the hole(don't thread in) does it stay or get blown off?
does it have a miss? how many miles. what air filter is on it?
could be rings, scored cylinder(s) or a hole in a piston(s) nothing else will cause pressure in the crankcase.
Reply With Quote