View Single Post
  #4  
Old 03-03-2013, 09:21 AM
RamTech's Avatar
RamTech RamTech is offline
Dodge Ram Forum Senior Member!

 
Join Date: Nov 2009
Location: Johnson City, TN
Age: 44
Posts: 12,120
Gender: Male
Vehicle: 2004 Dakota Club Cab 4X4
Trim Level: SXT
Color: Bright Silver
Engine: 2002-2008 226ci (3.7L) Magnum/PowerTech V6 215hp 235lb/ft
Rep Power: 14
Rep:1824
RamTech has a brilliant futureRamTech has a brilliant futureRamTech has a brilliant futureRamTech has a brilliant futureRamTech has a brilliant futureRamTech has a brilliant futureRamTech has a brilliant futureRamTech has a brilliant futureRamTech has a brilliant futureRamTech has a brilliant futureRamTech has a brilliant future
Default

08 - Electrical/8L - Lamps and Lighting/Lamps/Lighting - Interior/LAMP, Reading/Removal

REMOVAL




NOTE:On vehicles equipped with an optional overhead console the standard front dome lamp is replaced by two combination dome and reading lamps that are integral to the console housing. Each of these lamps is controlled by the door ajar switches on the courtesy lamp circuit, but also are independently controlled by a switch that is activated by depressing the lamp lens. The bulb types and service procedures are identical for both of these lamps.

NOTE:The overhead console reading lamp switches and bulb holders are serviced as a unit with the overhead console wire harness.



  1. Disconnect and isolate the battery negative cable.
  2. Using a small thin-bladed screwdriver, gently pry near the front of the lamp lens between each side and the overhead console housing (1) to unsnap the pivot tabs (3) on the lens from the pivots in the lamp housing.
  3. With the lens disengaged from both pivots, pull the lens forward far enough to disengage the switch tab (2) on the rear edge of the lens from the slot in the rear of the overhead console lamp housing.
  4. Remove the lens from the housing.

  5. Firmly grasp the bulb (1) and pull it straight out of the socket.
Reply With Quote