Thread: sway bars
View Single Post
  #9  
Old 04-06-2013, 05:13 PM
autobred's Avatar
autobred autobred is offline
Dodge Ram Forum Senior Member!
 
Join Date: Aug 2010
Location: Southern Md
Age: 46
Posts: 727
Gender: Male
Vehicle: sold* 10' R/T... 13' R/T
Trim Level: R/T
Color: black
Engine: 2009-20?? 345ci (5.7L) Hemi V8 390hp 407lb/ft
Rep Power: 5
Rep:142
autobred will become famous soon enoughautobred will become famous soon enough
Default

Quote:
Originally Posted by hodgeee View Post
Well, I have the Hellwig front and rear bars on my truck now, but I will admit, I was expecting more. I got a big improvement adding to the rear, since my truck didn't have one stock, but after swapping the front, the front end improvement only felt marginal compared to stock, where it was a night and day difference in the rear, but again, no stock sway in the rear.

I did notice that the front is 5/16" thicker, and the rear is 1/8" thicker. If this will reduce roll more, even a little bit more, I would swap them, cause I want maximum cornering, regardless that this is a truck or not! I am going to call them first thing tomorrow and call Hellwig first thing and see what the spring rate is on these bars.

The Hellwigs are solid, I do not know yet if the Aadco sways are hollow or solid.
I'm thinking of going aftermarket on mine also. Where did you purchase the hellwigs from? What swayed you "no pun intended" to going with hellwig over addco, diameters? thanks
__________________
Reply With Quote