DODGE RAM FORUM - Ram Forums & Owners Club! - Ram Truck Forum - View Single Post - 2013 Ram R/T 4 and 6 inch drop project.....
View Single Post
Old 05-03-2013, 08:28 AM
sowardcustoms's Avatar
sowardcustoms sowardcustoms is offline
Dodge Ram Forum Senior Member
Join Date: Jan 2010
Location: Burleson,TX
Age: 40
Posts: 490
Gender: Male
Vehicle: 2013 Ram R/T
Trim Level: R/T
Color: Gray
Engine: 2009-20?? 345ci (5.7L) Hemi V8 390hp 407lb/ft
Rep Power: 8
sowardcustoms will become famous soon enoughsowardcustoms will become famous soon enough

Ok its completed it was difficult but looks awesome I was able to use the 2" drop spindles with the aluminum control arms. However they will not work just bolt on. You will have to machine or grind out the area in front of the lower ball joint. And then comes the next problem the coil spring its shorter from the factory laying it against the 2" drop coil they were the same length. So I had to cut it a half coil at a time till I got the appropriate drop can you say pain in the a$$.. I have pics of the install and finish stance however my work computer will not let me use photobucket so it will be later today before I can post pics. so 2013 guys be prepared the front sucks the back same as 09 and up... project complete.....
Reply With Quote