View Single Post
  #5  
Old 05-11-2013, 08:03 PM
JBassRN JBassRN is offline
Dodge Ram Forum Newcomer
 
Join Date: Apr 2013
Location: Texas
Age: 27
Posts: 7
Gender: Male
Vehicle: 2011 Dodge Ram
Trim Level: Laramie
Color: Red
Engine: 2009-20?? 345ci (5.7L) Hemi V8 390hp 407lb/ft
Rep Power: 0
Rep:17
JBassRN is on a distinguished road
Default

I just did the same thing and was able to install without completely taking out. Go to the back seat and on the console where the vents come out, that whole piece will just pop off. Then move your drivers seat all the way foreward and look near the floor on the bottom on the console *looking from the back seat*. Remove this screw. This piece will not pop off (some), just enough to get your hand in to secure bolts. Then drill holes into the console. There is about a 1inch gap from the console to the outer piece. Then secure holster and put back together.
Attached Images
File Type: jpg resize 4.jpg (67.6 KB, 45 views)
File Type: jpg resize.jpg (71.8 KB, 45 views)
File Type: jpg resize 2.jpg (62.7 KB, 53 views)
File Type: jpg resize 3.jpg (86.8 KB, 54 views)
Reply With Quote