View Single Post
  #33  
Old 05-16-2013, 11:09 AM
jeepguy's Avatar
jeepguy jeepguy is offline
Dodge Ram Forum Member
 
Join Date: Apr 2013
Location: Newport News, VA
Posts: 240
Gender: Male
Vehicle: 2013 Ram Sport
Trim Level: Sport
Color: Deep Cherry Red
Engine: 2009-20?? 345ci (5.7L) Hemi V8 390hp 407lb/ft
Rep Power: 0
Rep:29
jeepguy is on a distinguished road
Default

Quote:
Originally Posted by velocityss1985 View Post
The CANbus signal is already converted to speaker level where you made your connector. I am assuming this because the factory alpine amp is up stream from your connection, that is why i was questioning the speaker signal to RCA connection. An easy way to do this is speaker level input on the amp, which is not a very good way to hook an amp up although it would work. The next best thing is to get the LC2i in which I mentioned above and tie the speaker leads into that and it will convert the signal to RCAs and then plug into the amp, plus there are additional adjustments as well as a remote turn on wire, where as cheap line level convertors dont have the adjustments or the amp remote turn on wire.. Just food for thought, good luck!!! I still want to do the backup camera mod you are doing.
Jeff
I meant the CANbus signal for the amp turn on.
Reply With Quote