View Single Post
  #7  
Old 05-16-2013, 10:34 AM
ModifiedBEAST ModifiedBEAST is offline
Dodge Ram Forum Junior Member
 
Join Date: May 2013
Location: Gainesville, FL
Posts: 45
Gender: Male
Vehicle: 99
Trim Level: slt
Color: blue
Engine: 1998-2001 360ci (5.9L) Magnum V8 245hp(standard), 250hp(Sport package)
Rep Power: 0
Rep:20
ModifiedBEAST is on a distinguished road
Default

a bolt is broke off into the front yoke for the 4x4 driveshaft. i was gonna just take the yoke off and let a friend remove the broken bolt. any advice on removing the yoke? the whole thing spins. i have a bad vacuum line or something so it wont lock into place. or should i leave it on drill the bolt out. the drill i tried using was a pos. should i also heat the bolt up?

i looked and rear only has skyjacker shocks. looks like i'll need 2 or 3 inch blocks in the rear. they just sit under the leaf springs?
found the kit on autozone.com, comes with longer u bolts and block. should i do 2 or 3"?

should i leave bug shield on or remove? in the first pic, i started removing the middle piece.
looks plain to me now.

white stripes? figure i can try it, if it looks ugly, i'll peel them off. going to use matte white plastidip. can do vinyl but only if i like it.

should i add a 4th gen "1500" emblem beside the RAM emblems?

i have the 4th gen 4x4 emblem on the right side of the tail gate. was thinking of adding DODGE or RAM to the left side.

should i add cab lights?
__________________
...

Last edited by ModifiedBEAST; 05-16-2013 at 10:42 AM.
Reply With Quote