View Single Post
Old 05-16-2013, 10:21 PM
dwanton's Avatar
dwanton dwanton is offline
Dodge Ram Forum Senior Member
Join Date: Jan 2013
Location: southern jersey
Age: 45
Posts: 459
Gender: Male
Vehicle: 2013 power wagon 2500 loaded
Trim Level: crew cab loaded
Color: black
Engine: 2010-20?? 345ci (5.7L) Hemi V8 383hp 400lb/ft (2500/3500)
Rep Power: 4
dwanton will become famous soon enough
Default video installing hubcentric spacers

i needed to get some space between the upper control arm and the new tires I bought .

tires are nitto mud grapplers 33x12.5x20's and a 1.5 front level kit .

I ordered a set of custom made hubcentric spacers cost was $90 plus shipping.
this is who makes them -- I talked to Junior

3/8 is the smallest that they make due to the thickness of the lip on the factory rotor.

if your rotor has never been replaced or taken off you will have to remove the 2 aluminum washers with a pair of needle nose pliers.

I only did the front for now because I wanted to see what it looked like and if they were the thickness I needed.

after installing the spacers , I turned the wheels all the way in both directions and they don't hit the sway bar , upper control arms or anything else. But I am sure if I went off road they might hit .

click on the picture to play the video

2013 power wagon 2500 - 5.7 everything but leather.

Last edited by dwanton; 05-16-2013 at 10:29 PM.
Reply With Quote
Sponsored links