View Single Post
  #3  
Old 05-22-2013, 08:34 AM
tjbiker031's Avatar
tjbiker031 tjbiker031 is offline
Dodge Ram Forum Senior Member!
 
Join Date: Dec 2011
Location: Bradenton, FL
Age: 30
Posts: 307
Gender: Male
Vehicle: 2002 Dodge Ram
Trim Level: SLT - Quad Cab
Color: Graphite Metalic
Engine: 2002-2007 287ci (4.7L) PowerTech V8 235hp 295lb/ft
Rep Power: 4
Rep:118
tjbiker031 will become famous soon enoughtjbiker031 will become famous soon enough
Default

Honestly i would just cut those clamps off and put hose clamps on them. The heat sheilding should prevent them from melting if you are concerned with that.

Also to get that subborn SOB off, I would just cut the wire at the sensor, double wrench it (useing the box end) with the largest wrench possible and use your friend, Mr Leverage, to do the hard work...just watch your knuckles.

You can also use a special socket make for removing O2 sensors, but i would never try a line wrench on these (it always ends badly)
__________________
Show your thanks with the REP icon.

Get your Factory Manuals here!! <link fixed>
Reply With Quote