View Single Post
  #1  
Old 05-27-2013, 10:32 PM
ramaries ramaries is offline
Dodge Ram Forum Senior Member!
 
Join Date: Apr 2013
Location: whereIcan
Posts: 221
Gender: Male
Vehicle: 2013 Ram
Trim Level: Outdoorsman
Color: Blue
Engine: 2013-20?? 220ci (3.6L) Pentastar 305hp 269lb/ft
Rep Power: 0
Rep:39
ramaries is on a distinguished road
Default Confused: Exact 8.4AN specification of radio output frequency to different speakers

Does the front door have a full range signal coming to it or a crossover signal; if it is a crossover signal is it active (inside before amp) direct from the 8.4AN or passive at the speaker?

Same question for the 3.5, 2.5 headliner, rear door, and sub. Are there obvious passive crossovers near the speakers?

I see folks kinda grabbing speakers and putting in without much design going on - do we even know the frequencies the speaker wires are carrying; is the crossover built in to the 8.4AN and full range signal not available?

Or are there preamp outputs direct from the 8.4AN to plug into an active crossover then amp?

For instance if I wanted to put components in front doors is there a crossover before the signal so that if I used a passive crossover with a 6.5 and tweeter would it interact? If it is not a full range signal coming into the door then what freakin use is it to put in a component system?
Reply With Quote
Sponsored links