Thread: Eyebrow Tint
View Single Post
  #18  
Old 05-30-2013, 06:18 AM
scrappy scrappy is offline
Dodge Ram Forum Senior Member!
 
Join Date: Feb 2013
Location: princeton
Age: 39
Posts: 107
Gender: Male
Vehicle: '12 ram 3500
Trim Level: laramie limited
Color: mineral grey
Engine: 2011-20?? 409ci (6.7L) Cummins Turbo Diesel 350hp 800lb/ft
Rep Power: 0
Rep:29
scrappy is on a distinguished road
Default

Quote:
Originally Posted by dodgert View Post
it follows the contour of the windshield ive had about 35 cars tinted and they all did it the same way
Yup, the cut is perpendicular to the surface of the glass the way they "always do it" and that is NOT how I want it. it will ALWAYS be like that when they use a straight cut on the lower edge of the tint and apply it to a curved windshield. Technically the pic I linked to earlier is ILLEGAL where I am from(it extends below the AS1 line on the windshield). If it doesn't extend below the line on this install it ends up being only about an inch tall @ the center of the windshield which completely makes it not worthwhile to have! But the way I "want" it, it will be the same size and NOT below the AS1 line anywhere and it will look just like the factory eyebrow just slightly lower and darker.
Reply With Quote