View Single Post
  #2  
Old 05-31-2013, 12:49 PM
Screamintrashcan Screamintrashcan is offline
Dodge Ram Forum Senior Member!
 
Join Date: Feb 2011
Location: Alston, MI (BRRrrr)The shores of Gitche Gume
Age: 56
Posts: 456
Gender: Male
Vehicle: 95 & 98 1500 Ram 4x4s
Trim Level: SLT & Sport
Color: 1 Blk,1 Red
Engine: 1994-2001 318ci (5.2L) Magnum V8 220hp
Rep Power: 0
Rep:36
Screamintrashcan is on a distinguished road
Default

Some people say their units don't have the test port, on both of mine, the port is on the drivers side rail over the head, pointed straight up. If no test point you would need to get out your tubing cutter and a compression tee, and install a schrader valve on the branch. (you would need two cuts if you cut into, over the eng, not recommended) I would probably cut under the truck somewhere, then you could do as you wished, with a schrader valve, a pvc tee, fuel hose good to at least 50 PSI (system pressure should be about 40 - 43 max)and 4 hose clamps to go over the hose and barbs .
Reply With Quote