DODGE RAM FORUM - Ram Forums & Owners Club! - Ram Truck Forum - View Single Post - Main firewall bulkhead grommet replaceable?
View Single Post
  #2  
Old 06-08-2013, 11:38 AM
RogerRamJet's Avatar
RogerRamJet RogerRamJet is offline
Dodge Ram Forum Senior Member


 
Join Date: May 2013
Location: Mansfield, TX
Age: 52
Posts: 17,495
Gender: Male
Vehicle: 2014 RAM 1500
Trim Level: Sport 4X4 CC
Color: White
Engine: 2013-20?? 345ci (5.7L) Hemi V8 395hp 410lb/ft
Rep Power: 18
Rep:2968
RogerRamJet has a reputation beyond reputeRogerRamJet has a reputation beyond reputeRogerRamJet has a reputation beyond reputeRogerRamJet has a reputation beyond reputeRogerRamJet has a reputation beyond reputeRogerRamJet has a reputation beyond reputeRogerRamJet has a reputation beyond reputeRogerRamJet has a reputation beyond reputeRogerRamJet has a reputation beyond reputeRogerRamJet has a reputation beyond reputeRogerRamJet has a reputation beyond repute
Default

Quote:
Originally Posted by vonirkinshtine View Post
So...long story short, is the big, main, rubber firewall grommet on the driver's side of the engine bay (see attached picture) replaceable?

(2005 Ram 1500 SLT, quad cab, 4.7L, 4WD)
Technically, yes. However, to do it correctly, you'd have to remove the wire harness. I'm thinking you could probably cut the grommet on one side to fit over the harness and then seal it with some crazy clue or something that will fuse the rubber together.
__________________
Life is hard... It's harder if you're stupid!
Today is a good day to be a RAM owner!
Reply With Quote