View Single Post
Old 06-09-2013, 07:34 PM
Hardware's Avatar
Hardware Hardware is offline
Dodge Ram Forum Senior Member
Join Date: Jun 2012
Location: Atlantic Canada
Posts: 464
Gender: Male
Vehicle: 2012 2500 4x4 Crew-Cab
Trim Level: Outdoorsman
Color: Black over Grey
Engine: 2011-20?? 409ci (6.7L) Cummins Turbo Diesel 350hp 800lb/ft
Rep Power: 0
Hardware is on a distinguished road

Originally Posted by Cowboy Medic View Post
...I also promised a couple of photos of the front reciever without the winch in the way. So here that is. I was initially concerned that it would block too much of the coolers, but as you can see plenty of air can still get around it. There is a brace that stops anything from being put through the receiver too far so that was a nice touch as well. This is made by Draw-Tite and I picked it up through my local NAPA store for $180.00. I had paid more than $200.00 to have one made by a welding shop before so I am pleased overall.

Crap, something I didn't know I needed until now!

What winch do you use in there?

Did you install it yourself?

Which part # is this yours?


or 65057?

What other uses do you have in mind for it?

It appears either will fit - any idea what the difference is?
MODS: BAKFlip F1; Head Rack; WeatherTech mud-flaps, vent visors & bug deflector; Cabella's rear seat cover; cabin air filter; Geno's Grill Quick Release Kit, PIAA Xtreme headlamps (Highs, Lows and Foglamps), WeatherTech DigitalFit Floorliners.

Last edited by Hardware; 06-09-2013 at 07:37 PM.
Reply With Quote