View Single Post
  #3  
Old 06-12-2013, 11:28 AM
fastNugly @ BP's Avatar
fastNugly @ BP fastNugly @ BP is offline
Bully's Performance

 
Join Date: Mar 2012
Location: Toronto
Posts: 17,964
Gender: Male
Vehicle: '15 Ram 1500 Longhorn EcoD
Trim Level: CC, 6'4", 3.92, LSD
Color: Granite Crystal
Engine: 2014-20?? 182.3ci (3.0L) L630DOHC V6 240hp 420lb/ft Eco-Diesel
Rep Power: 14
Rep:1787
fastNugly @ BP has a brilliant futurefastNugly @ BP has a brilliant futurefastNugly @ BP has a brilliant futurefastNugly @ BP has a brilliant futurefastNugly @ BP has a brilliant futurefastNugly @ BP has a brilliant futurefastNugly @ BP has a brilliant futurefastNugly @ BP has a brilliant futurefastNugly @ BP has a brilliant futurefastNugly @ BP has a brilliant futurefastNugly @ BP has a brilliant future
Default

Quote:
Originally Posted by SilverRam318 View Post
OK so I have a 6 inch zone lift on my RAM then installed billsteins at 1.4. Then moved them to 2.8. However took it to shop today to have a rear coil replaced and they said that the billsteins are doing more damage then good to my truck? they said that the zone preloaded spacer in the front has to be removed and left out the truck in order to properly install the bilsteins said causes to much stress on coil? Was the zone spacer supposed to be removed permatley to install billsteins? any help would be appreciated
yes they are right!!!
REMOVE THAT PRE-LOAD ASAP!

You CANNOT stack a pre-load and the Bilsteins. The only thing that stays is the strut spacer block.

But I am guessing the Bilsteins are already installed and they did remove the pre-load? If so, that is a good thing.
Plus, it would be VERY difficult to install the Bilsteins with that pre-load in and your CVs would be jacked at a ridiculous angle
__________________
For forum member pricing, email me @
sales@bullysperformance.com

2014 Ram Hemi Tuning now available from DiabloSport get yours today!
OB-Trinity T-1000's only $489!
100% Guaranteed to work or we will replace it for free!
Reply With Quote