View Single Post
  #7  
Old 06-15-2013, 11:01 PM
Ramzaq Ramzaq is offline
Dodge Ram Forum Senior Member!
 
Join Date: Aug 2010
Location: Northern California
Posts: 581
Gender: Male
Vehicle: 2009 Ram CC 4X4
Trim Level: SLT, Big Horn
Color: Black Pearl coat
Engine: 2009-2010 345ci (5.7L) Hemi V8 390hp 407lb/ft
Rep Power: 5
Rep:229
Ramzaq has a spectacular aura aboutRamzaq has a spectacular aura aboutRamzaq has a spectacular aura about
Default

Info is on here, just have to look around, maybe do a search. From my old post.

For those out of warranty and like to fix your own things, here is a quick guide for that clicking noise.

Chances are it is only the motor that is bad if it is clicking or thumping.
Not very hard to fix really. I think most of these cases are the motor gears stripping and not the doors themselves.

If you know how to take the center stack bezel around the radio off you are halfway there. Don't forget about the screw over the 115V out let. Take the bezel off then the two side 12V acc. plugs. Remove the ring bezel around the cup holder if equipped.

The culprit is the lower center motor, unplug remove two screws and remove.
If the gears are stripped you can position the big gear 180 out from the smaller gear. The door only travels about 120 degrees so won't hit the stripped part.

Reassemble and you should be good to go. 1 to 2 hours of your time. If you want to get a new motor it is about $40 from Chrysler.

Hopefully this is the extent of your problem.

Attached Images P8210400.jpg (89.2 KB, 28 views) P8210401.jpg (95.7 KB, 28 views) P8210402.jpg (82.0 KB, 26 views) P8210403.jpg (117.5 KB, 30 views) P8210404.jpg (119.0 KB, 27 views) P8210405.jpg (122.5 KB, 29 views) P8210406.jpg (124.4 KB, 32 views) P8210407.jpg (119.9 KB, 33 views) P8210408.jpg (103.7 KB, 34 views) P8210409.jpg (55.7 KB, 34 views)
Reply With Quote