View Single Post
  #1  
Old 06-17-2013, 03:36 PM
thekid0311 thekid0311 is offline
Dodge Ram Forum Member

 
Join Date: Apr 2013
Location: Marion NC
Age: 25
Posts: 74
Gender: Male
Vehicle: 2005 Doge Ram Quad cab 4x4
Trim Level: Daytona
Color: Silver
Engine: 2003-2008 345ci (5.7L) Hemi V8 345hp 375lb/ft
Rep Power: 0
Rep:15
thekid0311 is on a distinguished road
Default Transmission temp gauge help.

Ok I put a T fixture on my outlet line of my tranny. I used 3/8ths compression fittings to clamps down the ends of where I cut into the line and then I have a 3/8th to 1/8th reducer on the end that sticks up for my sender. Its been JB welded so I have a warm and fuzzy that it wont leak. Ive got it all wired up and ive got power and Im getting a temp reading of 68 on gauge but it doesn't move from there. I have the sender grounded to the O2 sensor of the cat. Is that causing interference and not reading a temp or is it just a bad sender? Thanks in advance for the help.
__________________
Men will follow out of fear but will die over respect
Reply With Quote
Sponsored links