View Single Post
  #2  
Old 06-18-2013, 01:55 PM
Designflaw's Avatar
Designflaw Designflaw is offline
Dodge Ram Forum Member
 
Join Date: Jan 2013
Location: Lexington Ky
Age: 46
Posts: 341
Gender: Male
Vehicle: 2013 Ram 1500 4x4 Sport
Trim Level: Sport
Color: Red
Engine: 2009-20?? 345ci (5.7L) Hemi V8 390hp 407lb/ft
Rep Power: 0
Rep:40
Designflaw is on a distinguished road
Default

Don't know if its right or wrong, but I put the screws and washers to the front. Also, the AC line I pushed the mounting bracket down about 1/4-1/2" at the fender and everything fit fine. You can see my PVC filter on the left vs. the right (before I cut it back some) I wanted to keep the Engine Cover without cutting it at the new filter location next to the Oil fill, so I just used the whole pipe brought it back over to the left side, drilled a small hole in the cover and used a wire tie to hold the pipe in place, cut the pipe back to the cover, then used the boot and filter.
Attached Images
File Type: jpg CAI front.jpg (87.3 KB, 39 views)
__________________
2013 CC Sport 4x4: 3.55, 20% Tint, Line-X, fender flares, mud flaps, Weather Techs, bed cover, 2.5 Leveling kit, Blacked out emblems, Vararam Air Grabber
2008 M109R LE, 1999 TL1000R, 2003 Yamaha Golf Cart :hah:
Reply With Quote