DODGE RAM FORUM - Ram Forums & Owners Club! - Ram Truck Forum - View Single Post - Trigger pulled on hypertech interceptor
View Single Post
Old 06-20-2013, 07:01 PM
guru1ofatl's Avatar
guru1ofatl guru1ofatl is offline
Dodge Ram Forum Member
Join Date: May 2013
Location: Earth
Posts: 61
Gender: Male
Vehicle: 2013 Ram 1500
Trim Level: Express
Color: Black
Engine: 2009-20?? 345ci (5.7L) Hemi V8 390hp 407lb/ft
Rep Power: 0
guru1ofatl is on a distinguished road

Received mine today and can't say I am terribly pleased with it at the moment.

Installed it and found the truck hard to start and the check engine light was on. Cycled the ignition and the EVIC displayed "service electronic braking system" and "service electronic throttle control". Removed and reinstalled the hypertech harness one sensor at a time, turning on the ignition after each to check for faults. Everything was fine after the IAT and cam sensors were connected but once the MAP was connected the faults returned.

The unit is back in the box and I will contact Hypertech followed by the vendor for assistance. Will let you know how it works out.
Reply With Quote