View Single Post
  #2  
Old 06-21-2013, 05:43 PM
Warlock III Warlock III is offline
Banned
 
Join Date: Aug 2010
Location: Earth...DUH!
Posts: 7,870
Gender: Male
Vehicle: 95
Trim Level: Cloaking
Engine: 1994-2001 318ci (5.2L) Magnum V8 220hp
Rep Power: 0
Rep:1776
Warlock III has a brilliant futureWarlock III has a brilliant futureWarlock III has a brilliant futureWarlock III has a brilliant futureWarlock III has a brilliant futureWarlock III has a brilliant futureWarlock III has a brilliant futureWarlock III has a brilliant futureWarlock III has a brilliant futureWarlock III has a brilliant futureWarlock III has a brilliant future
Default

Well, since the heads aren't side specific there shouldn't be a problem unless it was done at the manufacturer. Have you tried switching them? I realize that you may have already torqued one on so it may be prudent for you to return/bench compare it from the place you purchased it. It may not have been machined correctly.

I almost want to suggest that you get it lined up and start snugging the bolts sown in sequence a little at a time as the tolerance may be very close on the pins. But I don't want to see you crack the head at your expense. I've done it (not cracked the head but alternated working my way down) and it takes patience.

Don't attempt to mount the head if you're not comfortable with the fit.

Last edited by Warlock III; 06-21-2013 at 05:46 PM.
Reply With Quote