DODGE RAM FORUM - Ram Forums & Owners Club! - Ram Truck Forum - View Single Post - DIY catch can installed with ball valve
View Single Post
Old 07-09-2013, 12:17 AM
BlownGP's Avatar
BlownGP BlownGP is offline
Dodge Ram Forum Senior Member
Join Date: Jul 2012
Location: Houston/Baton Rouge
Posts: 351
Gender: Male
Vehicle: 2009 RAM CC Sport
Trim Level: Sport
Color: Sunburst Orange Pearl
Engine: 2009-20?? 345ci (5.7L) Hemi V8 390hp 407lb/ft
Rep Power: 0
BlownGP is on a distinguished road

Sweet..Lets make 1 for mine now lol..Notice any thing with the TB?Ill let ya know how the edge 2800 works out when i get home..Should do pretty well i hope lol!!
Lol, sure if ya want. Driving the truck today to work. I did notice a nice throttle response and it seems to pull harder in the upper RPMs. To be honest though I haven't much time to get a feel for the truck. Just been driving back and forth to work with a little WOT every so often.

Originally Posted by HOTRODHARLEY View Post
Isn't it just an empty can with an inlet/outlet..? A true air/oil separator has a divider and some kind of mesh/screen/filter media in it....
True as in what BP or Diablo Sport one sell? I guess since if you don't run one of those. Your not cool. lol

Most catch cans don't have mesh filter inside. So they must do something to sell them. This will at least be better than nothing..

I was looking at this one. Miget get later on since it mounts the same. Im going to see how mine works first
98 GTP-Mods? Yeah, lots of them
2009 Ram CC Sport- Mods very SOON!!!
Reply With Quote